User Guide

Pocket RefeRence Guide — 29
t 2606.13 (TLE 100)*
t 1158.28 (
TLE 150)
t 651.53 (
TLE 200)
t 514.79 (
TLE 225)
t 416.98 (
TLE 250)
t 289.57 (
TLE 300)
t 239.31 (
TLE 330)
t 104.25 (
TLE 500)
t 10424.53 (
TLE 50)
t 26.06
SQ M**
* “Tile 100” means “100 mm tile size.”
Note: Remember to round up (e.g., 2606.13 tiles
means you should purchase 2607 tiles)
**Repeats coverage area or square metres
calculated above.
Note: Tile sizes may not display in the order shown above.
Wallpaper: Rolls of
Find the number of wallpaper rolls needed for a
wall measuring 3m x 4m, or 12 square metres.
KEYSTROKE DISPLAY
o 0.
12mmw 2.30
WP Roll
(round up; purchase 3 rolls)
Note: Based on wallpaper coverage of 5.23 square
metres per roll. This value can be customized (see
“Using Custom Settings” following this section)
Paint: Finding Coverage Area
There are six (6) material keys that you may
use to store new non-standard material sizes:
Blocks, Bulk Bags, Paint, Studs, Custom Tile
and Wallpaper.
To store new material values (e.g., coverage
per bag, or paint coverage per litre) use the
s key. Just remember these values are
permanently stored until you change them.
(Only a
Çx or storing new values will
delete these registers.)
To recall your stored settings, press rand then
the Project Key (e.g.,
rp or rw ),
prior to completing a problem.
Again, note that performing a Clear All
(
Çx ) will erase all custom settings and
return your calculator to the default values, so
use this keystroke with caution.
Blocks (Custom Block Size)