Owner`s manual

SPA-SIDE CONTROL OPERATION
Your spa-side control panel consists of an LED display and convenient touch pads that
allow you to set the water temperature and adjust the skim/filter cycle settings, as well
as control the hydrotherapy jets, and light from spa-side.
LED DISPLAY
The LED display on your spa-side control panel continually shows the spa’s actual
water temperature. In certain situations, it will also display other messages. See
TROUBLESHOOTING section.
TEMPERATURE CONTROL
The set temperature range is from 80°F (27 °C) to 104°F (40°C) (Temperatures of
any setting may rise slightly depending on the current use and condition of your spa,
and on outside temperature).
The factory-set temperature is 102°F (39°C). Whenever power is disconnected and
then reconnected to the spa, the water temperature will automatically seek the last set temperature.
Pressing the “TEMP s” button displays the spa’s set temperature. To increase the set temperature, press the “TEMP s”button again, once for each degree
of increased temperature desired. If you hold the button down, the set temperature will increase by one degree every half second. When the set temperature
has been reached, the “READY” icon will display.
Pressing the “TEMP t” button displays the spa’s set temperature. To decrease the set temperature, press the “TEMP t” button again, once for each degree
of decreased temperature desired. If you hold the button down, the set temperature will decrease by one degree every half second. When the spa water has
reached the set temperature, the “READY” icon will display.
JET PUMP CONTROL
Pressing the “JETS” button changes the jet pump functions, depending on the number of presses:
Olympia Spa Model only:
1st press: Two-speed jet pump runs on low speed
2nd press: Two-speed jet pump runs on high speed
3rd press: One- and Two-speed jet pumps run on high speed
4th press: One-speed jet pump runs on high speed
5th press: Both jet pumps are off
Cumberland
®
, Aventine
®
, and San Gabriel
TM
Spas only:
1st press: Two-speed jet pump runs on low speed
2nd press: Two-speed jet pump runs on high speed
3rd press: Jet pump off
• The pump on high speed automatically turns off after operating for one hour. The pump on low speed automatically turns off after operating for one hour.
• When the jets are active, the JETS icon on the control panel will illuminate.
LIGHT CONTROL
Your Highland spa is equipped with a blue LED light. Press the LIGHT button to turn it on. Press it a second and third time to dim the light to
medium and low Press it a fourth time to turn it off. The light automatically turns off after six hours. When the light is active, the LIGHT icon on
the control panel will illuminate. For enhanced spa enjoyment, an optional six color wheel light feature is available to create your desired
ambiance.
MYSTIQUE
®
LED LIGHTING (OPTIONAL)
The Mystique LED lighting system allows you to customize up your spa experience through different multi-colored lights: blue, aqua, green, amber, red, and
magenta. You can choose one stationary color or you can cycle through all the colors with the automatic color wheel.
To install Mystique LED lighting system, you will need to contact your Caldera
®
Dealer.
To activate, press the “SET” button, then the “LIGHT” button on the control panel. The LIGHT icon will flash once color wheel is active. To select a specific color,
push the “LIGHT” button (within 5 seconds) while the desired color is displayed. If 5 seconds have passed after color wheel activation, you will need to press “SET”,
then “LIGHT” to select a specific color. The Mystique LED lighting option is a great way to personalize your spa experience.
12
OPERATING INSTRUCTIONS
Display
Jets Button
Light Button
Temperature Down
Temperature Up
Set Button