Owner`s manual

Pre-Delivery Instructions
Page 12
IMPORTANT: The following must be followed to properly install the equipment compartment door.
• Place top of door or panel directly below bartop against the frame of the spa. For Utopia spas, first lift the
fiber optic cable out of the way.
• Push bottom of door or panel against the spa frame.
• Slide door or panel upward (pushing in on center of door to ensure door clips catch) until screw holes line
up, making sure that the exterior fiber optic light cable will fit into the fixture.
• Slightly pull on door or panel. If door remains against the spa, then replace the screws.
• If the door does not lock into position, repeat the previous steps.
*PROVIDED WITH SPA.NOTE: ALL WIRING SHOULD BE COPPER.
** Refer to NEC 250-122 (table)
NOTE: The wire connections to GFCI breakers are for reference only. Always ensure the white neutral wire is connected to the load neutral of the 30 amp breaker.
Power
jumpers
** Refer to NEC 250-122 (table)
*PROVIDED WITH SPA.NOTE: ALL WIRING SHOULD BE COPPER.
** Refer to NEC 250-122 (table)
NOTE: The wire connections to GFCI breakers are for reference only. Always ensure the white neutral wire is connected to the load neutral of the 30 amp breaker.
UTOPIA GENEVA
®
, TAHITIAN
®
& NIAGARA
®
WIRING DIAGRAMS
UTOPIA CANTABRIA
®