Owner`s manual
23
OPERATING INSTRUCTIONS
LIGHT CONTROL
The “LIGHT” button activates the light and controls the intensity of the light. Pressing the “LIGHT” button operates the light as follows:
• 1st press of the “LIGHT” button – light will turn on to the maximum intensity.
• 2nd press of the “LIGHT” button – light will turn to medium intensity.
• 3rd press of the “LIGHT” button – light will turn to low intensity.
• 4th press of the “LIGHT” button – light will turn off.
If the light is left on, it will automatically be turned off by the control system after six hours of continuous operation. The light symbol on the main control panel will also
turn off when the light is deactivated.
If the light will not turn on, make sure SPA LOCK is deactivated. SPA LOCK disables the controls on both the main and auxiliary control panel.
AQUATIC MELODIES
TM
MUSIC SYSTEM
(Available on
Elation
®
and Aspire
TM
)
The Elation and Aspire comes equipped with the Aquatic Melodies Surround Sound system. The system includes the following:
• Sony
®
CD AM/FM Stereo (with equalizer).
• Three Pop-Up Satelite Speakers.
• Subwoofer with independent amplifier (located inside spa between shell and removable panel on the right side).
• Water Resistant Remote Control with IR Sensor.
The operating instructions for both the CD AM/FM Stereo and the Remote Control have been included in the spa’s Owner’s Packet.
SPEAKER OPERATION
Your Elation or Aspire spa is equipped with three pop-up speakers.
To operate the pop-up speakers:
1. Press the button next to the speaker.
2. Rotate the speaker to the desired position (the speaker can rotate in either direction until it stops).
3. The pop-up speaker will only lower in one position. To lower, rotate the speaker until the two arrows point towards each other, then press down on the top
of the speaker until it locks into position.
The speaker nearest the filter lid has an IR sensor. This IR sensor allows you to operate the music system using the remote control. Simply point the remote at the
bottom center of the speaker grill where the sensor is located.
NOTE: The remote will not
work if the speaker with the IR sensor is lowered or if the speaker grill is not facing towards you. Only the speaker closest to the filter lid has
an IR sensor.
Radio reception will vary depending on your location.
IMPORTANT: THE SPEAKER WILL ONLY LOWER IN ONE POSITION (WITH ARROWS ALIGNED), FORCING IT TO GO DOWN IN ANY OTHER POSITION WILL
DAMAGE THE SPEAKER MECHANISM.
Press button to raise the speaker
Speaker in initial raised position.
Rotate speaker to desired location.
Rotate speaker to return to the
initial raised position in order to
lower speaker.
Arrows pointing
towards each other