Submittal

QUALITY INNOVATION RELIABILITY
DESCRIPTION
CondenSAFE neutralizes condensate issued by modulating condensing gas
heating devices. A rigid pipe links the heating device to the CondenSAFE unit
to treat the condensate. The media in the unit neutralizes the condensate
pH to make it safe for the building components and most importantly, the
environment. CondenSAFE can contain up to three media bags so to suit
dierent heating devices capacity and condensate volumes to treat. Media
bags have a label to mark the installation date.The unit weighs 1.5 kg including
one media bag and the connections.
Refer to the following chart to determine how many sections need to be filled
with a media bag.
TECHNICAL DATA
MODEL
LENGHT WIDTH HEIGHT
INLET/
OUTLET
SIZING
UNIT MAX
CONDENSATE
FLOWRATE
*
1 SECTION 2 SECTIONS 3 SECTIONS
in cm in cm in cm MBH kWh gal/h L/h MBH kWh gal/h L/h MBH kWh gal/h L/h
CS6 Box 12 30.5 4 ¾ 12 5 ½ 14 ½’’ FNPT 525 154 2.1 8 1050 308 4.2 16 1575 461 6.3 24 6.3 GPH (24 LPH)
* Verify condensate flowrate on your appliance.
TYPICAL SPECIFICATIONS
Furnish and install as shown on plans a condensate neutralizer unit CondenSAFE manufactured
by Calefactio Solutions Inc. The condensate neutralizer unit must neutralize a condensate
volume of ________ L/h from a ________ MBH (________ kWh) capacity heating device, so be
equipped with ________ neutralizing media bags (#CSM2) with installation date label, in the
same amount of sections.
Quebec (Canada)
T 450 951.0818
F 450 951.2165
[e-mail]
calefactio.com
SUBMITTAL-EN-CS-201804
INLET
OUTLET
Including: 2 x ¾” glued fittings + 2 x ½” glued fittings + 3 pH test strips
Project: ___________________________________________________________ Representative: ____________________________________________________
Location: __________________________________________________________ Dated submitted: __________________________________________________
Engineer: __________________________________________________________ Approved by: ______________________________________________________
Contractor: ________________________________________________________ Date of approval: ___________________________________________________
OPTIONS
10 feet of flexible hose 2 x ¾” barbed
fittings AND 2 x ½” barbed fittings
(#CSHK)
2 wall mounting brackets (#CSB)
Additional media bag(s) (#CSM2)
Quantity ________
2 ½ in
3 in
WARRANTY
CondenSAFE oers a one-year limited warranty from the date of purchase. The warranty is only valid if the product is installed and used under
normal working conditions and for the purpose it was intended.