Instructions

Removing the Actuator
1. Move the manual open lever to the
lock open position.
2. Press the push button in and pull the
actuator up.
Installing the Actuator
1. Move the manual open lever to the
lock open position.
3. Verify the correct position of the valve
stem into the mating actuator hole.
Rotate stem if required to align.
4. Press the push button in and slide the
actuator onto the valve body, release
the push button.
SAFETY INSTRUCTION
This safety alert symbol will be used in this manual to draw attention to safety
related instructions. When used, the safety alert symbol means ATTENTION!
BECOME ALERT! YOUR SAFETY IS INVOLVED! FAILURE TO FOLLOW
THESE INSTRUCTIONS MAY RESULT IN A SAFETY HAZARD.
CAUTION: All work must be performed by qualified personnel trained in
the proper application, installation, and maintenance of systems in
accordance with all applicable codes and ordinances.
CAUTION: Over-tightening and breakage can occur with the use of
Teflon pipe joint compounds. Teflon provides lubricity so that care must
be exercised not to over-tighten joints. Failure to follow these instructions
could result in property damage and /or personal injury.
WARNING: System fluids are under pressure or temperature can be
hazardous. Be sure the pressure has been reduced to zero and the
system temperature is below 100ºF (38ºC). Failure to follow these
instructions could result in property damage and/or personal injury.
CAUTION: Avoid locations with excessive moisture, explosive vapors,
corrosive fumes or vibration. Failure to follow these instructions could result
in stress corrosion resulting in property damage and/or personal injury.
Caleffi shall not be liable for damages resulting from stress corrosion, misapplication or misuse of it products.
Caleffi North America, Inc.
3883 W. Milwaukee Road / Milwaukee, WI 53208
Tel: [phone] / Fax: [phone] / www.caleffi.com
© Copyright 2011 Caleffi North America, Inc.
1 2
3
4