Owner`s manual

G Series Gas Grills
LTR50001050, Rev. E
Appendix
www. ca l a me b bq . c o m
31
You will need:
7mm wrench, socket, or nut driver•
One or two 1.75mm orices (depending on •
your side burner)
Pipe compound suitable for natural gas•
Remove the grate, burner cap and burner a.
diffuser from the side burner.
Using a 7mm wrench, remove the orice for b.
the burner.
Apply a small amount of pipe compound to c.
the orice threads.
Screw in the orice until it is nger tight.d.
Tighten the orice with the 7mm wrench.e.
If you have dual side burners, repeat the f.
previous steps for the second burner.
Replacethesideburnerorices2.
Mark the rating plate3.
After conversion has been completed, mark the
rating plate as NG with an indelible marker.