Installation Guide
READ CAREFULLY BEFORE USE!
GLOSS
Do not use on laminate ooring.
For Wood Floors: For occasional use only to refresh worn nishes.
CAUTION: KEEP OUT OF REACH OF CHILDREN.
May cause eye irritation on contact. First Aid: If swallowed, drink
1 or 2 glasses of water. Contact your physician. For eye contact:
Flush eyes with water for 15 minutes. If applicable, remove
contact lenses and continue to ush with water.
Manufactured by Cal-Flor Accessory Systems
Oroville, CA (530) 534-1426
NEW INSTALLATIONS: For an even sheen and to add protection, apply 1-2 thin coats. Allow
30 minutes to dry between coats and 2 hours before replacing furniture. Great for occasional
use to clean, protect and freshen your oor. NOT a daily or weekly cleaner.
FLOOR PREP: Sweep or vacuum oor. New or very dirty oors should be pre-cleaned with a
vinyl cleaner to reduce chances of trapping dirt. Stains, black scu marks, grit, oil or other
contaminates should be removed rst. Deep scratches and scus in vinyl can be made less
visible by scrubbing in the direction of the grain with a green scrub pad. To refresh worn
wood, vinyl, tile or stone oors, strip well before using.
APPLICATION:
1) Apply a small amount directly to the oor in an “S” shape and spread immediately using a
clean, well-rinsed microber mop. Note: a sponge mop can apply too much polish.
2) Mop Single-Step evenly in the direction of the woodgrain; pressing extra hard to scrub out
stubborn dirt or spots. Rinse mop often with clean water. 3) Spots or stains not removed prior
to Single-Step drying may become permanent. 4) Avoid puddling or uneven mopping. Do not
walk on wet areas. 5) Remove excess Single-Step with the mop as you go; avoid leaving a thick
coat or puddles. To remove cloudiness or excess polish, use a standard vinyl stripper.
COVERAGE: 24-oz. bottle of Allure Single-Step covers up to 750 sq. ft. if applied in thin coats.
Do not apply in thick coats.
For questions or assistance, call 800-842-4888.
REFRESHER
INSTRUCTIONS FOR USE