Use and Care Manual
HSR Use and Care Manual
All surfaces should be clean and dry.
Shake pigment bottles thoroughly before and during use.
Application
1. Choose a color from the formula chart found inside this package that closest
matches the oor.
Follow directions for the Mixing Method which applies to your formula:
Method A: add the required amount of tint drops into the bowl and mix
thoroughly with the stick. Dip stick in the bowl and apply mix to mixing board
with a sharp tap.
Method B: add tint drops directly to the putty.
2. Measure the required amount of putty onto the mixing board by using the
reference lines, the nadd the required tint to putty and mix until the putty is
uniform in color.
3. Apply mixed putty to oor with a at plastic spatula slightly overlling the area
of the repair. Scrape o any surrounding excess with spatula. Allow to dry.
4. When micture is freshly dry, gently rub away the excess of the surrounding area
with a damp cloth until the surface is smooth.
5. If shrinkage occurs, re-apply the above mixture.
6. Once the repair is completely dry and graining or marbling is nished, apply
clear lacquer over the area using the brush.
For Wood, Laminate, Tile, Stone, Countertops,
Furniture, Engineered Flooring & more
Mix2Match™
Hard Surface Repair Kit
HEALTHAND SAFETY: KEEP OUT OF REACH OF CHILDREN
• Irritating to eye and skin. In case of contact with skin, wash
immediately with soap and water. In case of contact with eyes,
rinse immediately with plenty of clean, fresh water.
• If swallowed, rinse mouth and throat with cold water.
Immediately seek professional medical advice.
Take this label with you. DO NOT INDUCE VOMITING
CAUTION: EYE IRRITANT Read instructions carefully