Mount track 3/4" (19mm) from front edge of 2 Mount hinges on back i head jamb. of door. Lay panels face | (sez down on a flat surface. T = £T4.2x18 MIDPOINT — £m CIR) | a 8T4.2x32 == 1053/64" JAMB DOOR | @ (275mm) I Fasten pivot plates to top and bottom of doors as shown. RIGHT HAND SWING TOP OF DOOR 4 ~~ BOTTOM OF DOOR 3 tm 8T4 2x25 LEFT HAND SWING 1 53/64" (21mm) (Sm) (2mm) 4 Mark location of Bottom pivot bracket on jamb. Fasten in place with one ST4.2 screw. (x mm ST4.
Hang doors: Make sure Track pivot lock is in the unlocked position. (A) Fold doors and insert Door hanger plate into track groove. Place Top pivot into receptor of Track pivot lock. (B) When firmly seated, slide tab lock toward pin. Door now should be hanging from Top pivot. (C) Depress Bottom pivot bracket tokes arm and insert Bottom pivot. If no vertical adjust is needed, secure Bottom pivot bracket with other 2 screws. Use wrench for horizontal adjustment of Top pivot lock and Bottom pivot bracket.
Adjust Track stop Close doors, slide Track stop until it touches Door hanger plate. Open doors, move Track stop 1/8" (3mm) closer to Door hanger plate and tighten, Doors should "snap" shut yet open easily by a slight pull on the knob.
