Instructions / Assembly

CAREFULLY READ ALL INSTRUCTIONS BEFORE INSTALLING

Step 1 Tools Needed Step 2 Parts Included

You will need a Pencil, Phillips head screwdriver,Tape

Make sure ALL parts are included before installing.

measure, Drill, 7/16” Assorted Drill bits, 6” Phillips head

1 Top Plank, 1 Bottom Plank, 1 Left Outside Plank,

bit and 1/2” socket ratchet, 4ft Level,Rubber mallet, 4 Middle Planks.1 Right Outside Plank ,

Safety glasses, 4 Clamps(6") and 2 Clamps(50"). 1 Diagonal Cross Plank, 36 Screws.

Step 3 Expanded View

Step 4 Assemble Door Middle and Outside Planks

Place one plank flat on your work surface, making sure the

groove side of the panel is to the inside. Take next plank and

place it evenly into the first plank’s groove. Repeat steps with

the remaining planks. Make sure all planks are aligned top

and bottom as you go. Planks should be evenly spaced and

snug. The smooth outer edge of the left and right end planks

should be placed to the outside.

CAUTION

Assembled door is heavy and should be lifted

by 2 people at all times.Mishandling of heave

objects (i.e. doors) may cause injury. Safety

shoes should be worn at all times to prevent

injury.

PAGE 1
CAREFULLY READ ALL INSTRUCTIONS BEFORE INSTALLING Step 1 Tools Needed Step 3 Expanded View You will need a Pencil, Phillips head screwdriver,Tape measure, Drill, 7/16” Assorted Drill bits, 6” Phillips head bit and 1/2” socket ratchet, 4ft Level,Rubber mallet, Safety glasses, 4 Clamps(6") and 2 Clamps(50"). Step 2 Parts Included Make sure ALL parts are included before installing. 1 Top Plank, 1 Bottom Plank, 1 Left Outside Plank, 4 Middle Planks.
PAGE 2
Step 5 Assemble Top and Bottom Planks Place the top and bottom planks onto the assembled door planks with the pre-drilled opening side up. Make sure both panels are flush with the door edges on top and sides. There should not be any overhang. Planks should be evenly spaced and snug. Do not insert any of the screws at this point. Step 7 Secure Top and Bottom Planks Once all planks are flush and squre, secure the top and bottom planks with the screws provided. Using the clamps, secure all 4 corners.