Use and Care Manual

Step 1 Tools Needed Step 2 Parts Included

You will need a Pencil, Phillips head screwdriver,Tape Make sure ALL parts are included before installing.

measure, Drill, 7/16” Assorted Drill bits, 6” Phillips head 1 Top Plank, 1 Bottom Plank, 1 Left Outside Plank,

bit and 1/2” socket ratchet, 4ft Level,Rubber mallet, 4 Middle Planks.1 Right Outside Plank ,

Safety glasses, 4 Clamps(6") and 2 Clamps(50"). 2 K Planks, 1 Central Plank, and 56 Screws.

Step 3 Expanded View

Step 4 Assemble Door Middle and Outside Planks

CAUTION

CAREFULLY READ ALL INSTRUCTIONS BEFORE INSTALLING

Place one plank flat on your work surface, making sure

the groove side of the panel is to the inside. Take next

plank and place it evenly into the first plank’s groove.

Repeat steps with the remaining planks. Make sure all

planks are aligned top and bottom as you go. Planks

should be evenly spaced and snug. The smooth outer

edge of the left and right end planks should be placed to

the outside.

Assembled door is heavy and should be lifted by

2 people at all times.Mishandling of heave

objects (i.e. doors) may cause injury. Safety

shoes should be worn at all times to prevent

injury.

PAGE 1
CAREFULLY READ ALL INSTRUCTIONS BEFORE INSTALLING Step 1 Tools Needed You will need a Pencil, Phillips head screwdriver,Tape measure, Drill, 7/16” Assorted Drill bits, 6” Phillips head bit and 1/2” socket ratchet, 4ft Level,Rubber mallet, Safety glasses, 4 Clamps(6") and 2 Clamps(50"). Step 3 Step 2 Parts Included Make sure ALL parts are included before installing. 1 Top Plank, 1 Bottom Plank, 1 Left Outside Plank, 4 Middle Planks.1 Right Outside Plank , 2 K Planks, 1 Central Plank, and 56 Screws.
PAGE 2
Step 5 Assemble Top and Bottom Planks Place the top and bottom planks onto the assembled door planks with the pre-drilled opening side up. Make sure both panels are flush with the door edges on top and sides. There should not be any overhang. Planks should be evenly spaced and snug. Do not insert any of the screws at this point. Step 6 Step 8 Step 7 Secure Top and Bottom Planks Once all planks are flush and squre, secure the top and bottom planks with the screws provided.