Instructions

Configuration
Here you will find the complete settings / options available to configure your
own tuner. On the main menu, navigate to Configuration setting. Press OK
and you will see a list of options available.
Network
Wi-Fi Network
Add / Remove AP
Add AP - It will scan out a list of wireless network around.
Add AP (WPS button) - If WPS button is available on your router, you
can choose this option to quickly connect to your wifi network without
entering the password. Select this option on the radio and press OK,
it will show "Awaiting router info" on the display. Meantime, press the
WPS button on your router within one minute. It will time out if no
action is taken. It is strongly recommended to place your radio within
2 meters to the router to setup.
Note: In case the connection through WPS is not successful, repeat
the steps above and try again.
Remove AP - If you have already added a wireless network and want to
remove it, choose this option.
Note: Always place the radio within 2 meters of the Wi-Fi router for
setup.
AP: [ ]
If you have added more than one wireless network on the radio and
want to switch to another one, select this option to change.
Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as
received by the radio. Usually signal levels lower than -70dBm is at
weaker level and if it affects the reception of your radio, you may need to
optimize the router location or check any problem of the router itself.
IP
The IP is set Dynamic by default. Select to change Fixed IP
according to your network condition.
DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS
according to your network condition.
Wi-Fi Channels