CAR CD/MP3 PLAYER / RDS RECEIVER WITH USB INTERFACE, SD INTERFACE 3 1 OPEN 2 10 9 11 ID3 AS DISP PS MODE BAND MENU 6 5 PTY MUTE AUX 15 7 1 2 INT 4 3 RPT RDM 4 5 6 USB 14 8 13 1. PANEL RELEASE BUTTON 2. ENCODER VOLUME KNOB 3. SYSTEM MENU BUTTON 4. PRESET MEMORY BUTTONS 5. ENCODER TUNING UP/ DOWN & TRACK UP / DOWN BUTTON 6. POWER / MUTE BUTTON 7. MODE BUTTON 8. BAND/ BUTTON / PTY BUTTON 9. AUTOMATICALLY STORE / PRESET SCAN (AS/PS) BUTTON 10.
1. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs NOTES ON DISCS 1. A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc as follows. Handle the disc by its edge.
2. INSTALLATION Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
Removing the unit a. Frame b. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove down wards and attach it.) c. Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. a b c - DIN REAR-MOUNT (METHOD B) Installation using the screw holes on the sides of the unit.
3. DETACHABLE CONTROL PANEL(D.C.P) Removing The Detachable Front Panel 1. 2. Step 1 Open button Step 2 To remove the front panel: 1. Press the Panel Open Button. 2. After flipping down the front panel, push it rightwards ( Step 1 ), then draw the left of the front panel outwards ( Step 2 ). Attaching The Detachable Front Panel Step 2 Step 1 1.
4.
5. BASIC OPERATIONS 1) PANEL OPEN BUTTON ( OPEN ) Press this button to fold down the front panel. 6) POWER ON/OFF BUTTON ( ) press POWER/MUTE button or any other button on the front of the radio (except Open / Eject) to turn the unit on. And Long press POWER /MUTEbutton again to turn the unit off. 6) MUTE BUTTON (MUTE) Short press the MUTE button momentarily to mute the audio volume, and "Mute" will flash in the display. Press the MUTE button again to restore volume to the previous setting.
6. AUDIO / MENU OPERATIONS 3) AUDIO MENU ( MENU ) Press “ MENU ” button to access the Audio Menu. User can navigate thru the Audio Menu intems by pressing the MENU button. Once the desired menu item appears on the display, adjust that option by using the encoder volume knod within 5 seconds. The following menu items can be adjusted as descrided above. The unit will automatically exit the Audio Menu after 5 seconds of inactivity.
7. RADIO OPERATIONS 11) RADIO SIGNAL STRENGTH METER (RSLM) This is use to indicate the signal strength of current radio station broadcast. When you choose RADIO mode, it will show on the display. Best reception Worst reception 9) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1.PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2.
8.
9.CD OPERATIONS 13) CD SLOT Insert the disc into CD slot. The CD will begin to play. M1) PAUSE BUTTON ( PAU ) Press this button to pause CD play, press again to release pause. M2) INTROL BUTTON (SCN) Press this button, the first 10 seconds of each track will be played sequentially until this button is pressed again, then normal play will resume at the current track. M3) REPEAT BUTTON (RPT) Press this button, the current track will be played repeatedly until this button is pressed again.
PLEASE READ THIS INSTRUCTION CAREFULLY BEFORE OPERATING THE UNIT 10. USB DRIVE OPERATIONS COMPATIBILITY Due to the fast changing technology world, this unit may or may not be compatible to all the USB drive / device available with all the future technology, especially those USB drive / device which require to install a driver. Always choose a compatible USB drive / device which is compatible with this unit. P.1 NOTE: This unit is not compatible with portable Hard-Disk. START THE USB DEVICE MODE 1.
11. SD OPERATIONS 1.Press panel open button to release the front panel.(P.1) P.3 3.The SD card slot is located on the unit as indicated in (P.4). 4. Insert the SD card into the card slot in the correct direction until a “CLICK” sound is heard.(P.5) 5.Close the front panel.(P.6) P.4 P.5 Face Up P.6 P.2 Click Open button P.1 P.3 Insert the SD Card with Label up side Push in till heard a “click” Close the front Panel 6.
12.MP3/WMA OPERATIONS(ENCODER VERSION) Notes : This unit support : MPEG1/2/2.5/ Layer 2/3 WMA Version 7/8/9 Sampling frequency - MPEG1 : 32/44.1/48 KHz - MPEG2 :16/22.05/24 KHz - MPEG2.5 : 8/11.
ENTER BUTTON and continue to search the directory or file name in the directory by TUNE UP / DOWN Button (TUNE DOWN First).
13. SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ration Compact disc audio system Compact disc 44.1KHz 1bit 5-20,000Hz 2 stereo 70dB RADIO SECTION FM Frequency Range 87.5-108 MHz Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 10.
14. TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power Disc cannot be loaded or ejected Cause Solution The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to “ACC” The fuse is blown. Replace the fuse. Presence of CD disc inside the player.
