Installation guide
EN - 6
General Operation
Power On/Off Button
PresstheMUTE/ button to turn the unit on
when the vehicle ignition switch is on. Long
press to turn the unit off.
— — — — — — — — — — — — — — — — — — — —
Adjust Volume level
Rotate the VOL knob to adjust volume
level. Rotate it clockwise to increase and
anticlockwise to decrease the volume.
— — — — — — — — — — — — — — — — — — — —
Mode Button (SRC)
Press the SRC button to change between
Radio, DISC (when disc is in), USB(when
USB connected), SD/MMC card(when card
inserted), AUX play, BT audio, DAB.
— — — — — — — — — — — — — — — — — — — —
Disc Load/Eject
Load:Press toipdownthepanel.Insert
the disc into the slot .
Eject:Press toipdownthepanel.Press
toejectthedisc.
— — — — — — — — — — — — — — — — — — — —
Radio
Tonetunetheradio,press|<<or>>|briey.
Tosearchthestationautomatically,press|<<
or>>|formorethan2seconds.
Disc Playback
Trackskip:Press|<<or>>|brieytogotothe
next or previous track.
Trackseek:Press|<<or>>|formorethan2
seconds to seek the forward or previous track.
— — — — — — — — — — — — — — — — — — — —
AMS : Auto Memory Store
Press AMS briefly to scan the preset station
1-6 for 5 seconds each. Holdformore than
2 seconds,the6 strongest availablestation
will be automatically saved in the memory of
presetbuttons1-6.
— — — — — — — — — — — — — — — — — — — —
Auxiliary Input (optional)
Toaccessanauxiliarydevice:
1. Connectthe portableaudio playertothe
AUX interface.
2. Press the SRC button to select Aux-In
mode.
3. Press SRC again to cancel Aux-In mode
and go to the next mode.
— — — — — — — — — — — — — — — — — — — —
Display Selector (DISP)
This unit can display either the clock time or
radio frequency/DAB frequency/CD player
functions. Ordinarily, the radio frequency/
DAB frequency or CD player track indication
is displayed, but the unit will display the time
when the DISP button is pressed. The time
will display for approximately 5 seconds then
return to the radio/CD or DAB player function
display.
Note:
DABInformation(PressDispKey):
Clock Disp->DLS Info ->PTY Disp->Signal
GroupNameDisp->FrequencyDisp->BitRate
Disp->ServiceNameDisp
— — — — — — — — — — — — — — — — — — — —
Setting the Clock
The correct time of day can be set by pressing
and holding the DISP button.
Tosettheclock,performthefollowingsteps:
1. Turnthevehicleignitionandradioon.
2. PresstheDISPbuttontoviewtheclock.
3. With the clock visible on the display, press
and hold the DISP button until the time
displayashes.
4. Within 5 seconds, rotate the VOL knob
counterclockwisetoadjusttheminutesto
the desired setting. To change the hour,
rotatethe VOLknobclockwise to adjust
the hour to the desired time.
5. Press DISP button to confirm and exit
clock setting.