Operation Manual

EN - 15
Mounting bolt
rubber cushion.
1
2
3
Remove the
two screws.
Installation Guide
Installation Procedures
First complete the electrical connections, and
check for correctness.
— — — — — — — — — — — — — — — — — — — —
Reset
Press buttontoipdownthepanel.Then
presstheRESETbuttonwithapointedobject
to reset the unit to the original status.
Note: PresstheRESETbuttonwillerasethe
clock and stored stations.
Install the unit
Important:
Remove the two screws on the top of the unit
before installation.
Otherwise,theplayerwillnotwork.
Installing the panel
• Holdthepanelandensurethepanelfaces
dwonward, and at an angle set one side of
the panel in the panel bracket. Press the
other side of the panel until it locks.
• Pressthetopofpaneluntilitlocks.
— — — — — — — — — — — — — — — — — — — —
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below. The
dashboard should be 4.75mm - 5.56mm thick
in order to be able to support the unit.
1. Insetmounting collarinto the dashboard,
and bend the mounting tabs out with a
screwdriver.
 Makesurethatlockleverisushwiththe
mountingcollar(notprojectingoutward).
2. Securetherearoftheunit.
After fixing mounting bolt and power
connector,xtherearoftheunittothecar
body by rubber cushion.
3. Insert trim plate.
Mounting bolt
Rubber cushion
— — — — — — — — — — — — — — — — — — — —
Removing the unit
1. Switchthepoweroff.
1. Removethepanelandthetrimplate.
2. InsertbothT-Keysintoholeonthefront
of the set until they lock.
3. Pull out the unit.
Reset