Unit installation

1. Before finally installing the unit, connect the wiring temporarily and
make sure it is all connected up properly and the unit and system work
properly.
2. Use only the parts included with the unit to ensure proper installation.
The use of un-authorized parts can cause mal functions.
3. Consult with your nearest dealer if install-ation requires the drilling of
holes or other modifications of the vehicle.
4. Install the unit where it does not get in the driver's way and cannot
injure the passenger if there is a sudden stop, like an emergency stop.
5. If installation angle exceeds 30° from horizontal, the unit might not give
its optimum performance.
6. Avoid installing the unit where it would be subject to high temperature,
such as from direct sunlight, or from hot air, from heater, or where it
would be subject to dust dirt or excessive vibration.
After inserting the half sleeve into the dashboard, select the appropriate
tab according to the thickness of the dashboard material and bend them
inwards to secure the holder in place.
Installation using the screw holes on the side of
the unit
Select a position where the screw holes of the bracket and the screw
holes of the main unit become aligned (are fitted) and tighten the screws
at 2 places on each side.
Screw
Screw
Factory radio
mounting
bracket
Hook
Hook
Installation
INSTALLATION CAUTION
E - 3
Installation with the half sleeve
182
111
Dashboard
Half Sleeve
Screw
Attach the trim ring
Trim ring
Dashboard or
console
The outer trim ring, and half-sleeve are not used
for this installation.
The mounting box, metal half-sleeve, hook &
screws are not included in the packing.
NOTE
Attached the Front Panel
1
2
To attach the front panel back to the
unit chassis, please insert the right side
of the panel in the chassis until it is
correctly engaged. Press the left side
of the panel until the mechanism locks
it into place.