Operating instructions

18
announcement on or off.
TA mode: Seek, Alarm
Touch [Seek] or [Alarm] to select traffic
announcement’s active mode.
REG: On, Off
Touch [On] or [Off] to select whether identify
the regional code when tuning.
RDS CT: On, Off
Touch [On] or [Off] to select whether
synchronize clock time with the signal source.
BT Setting
Pair: On, Off
Touch [On] or [Off] to choose pair
automatically on or off.
Auto Connect: On, Off
Touch [On] or [Off] to choose connect
automatically on or off.
Auto Answer: On, Off
Touch [On] or [Off] to choose answer
automatically on or off.
PIN Code: Set
Touch [Set] button to open keypad, then
set the bluetooth password by the number
buttons. Touch
KEY PAD
13800138000
1
23
456
789
*
0#
the erase previous
number. Touch
KEY PAD
13800138000
1
23
456
789
*
0#
to conrm .The original
password is “1234”.
To reset the password, you should enter
the original password first, then input a new
password, touch
KEY PAD
13800138000
1
23
456
789
*
0#
to conrm, input the
password again to conrm.
Other Setting
SWC (Steering Wheel Control)
refer to <Basic Operations>.
TS: Adjust
Touch [Adjust] to calibrate the screen.
When the touch operation is not sensitive or
valid, you should calibrate the touch screen
through “TS Calibrate” function.
System Setup
(continued)
Device Connections
Notes of connection
• This unit is designed to be used in a
vehicle with a 12-volt battery and negative
grounding. Before installing this unit to a
recreational vehicle, a bus, or a truck, make
sure the battery voltage is appropriate for
this unit to be used, otherwise, install a
transformer by professional to convert the
output voltage to 12V.
• To avoid short circuit in the electrical
system, ensure that the negative battery
cable is disconnected before installation.
• To prevent short circuit in the wiring and
damaging to this unit, secure all wirings
with cable clamp or adhesive tape. Route
the wirings in a secured, out of heating
place without touching any moving parts
such as gear shift, handbrake, and seat
rails to prevent the wiring insulation being
melted / worn off.
• Never pass the yellow power cord through
the installation hole into the engine
compartment and connect to the car
battery. Otherwise, a high possibility of
serious short circuit to the electrical system
may occur.
• Replacing a new fuse with 15A rating
when the old one is broken, using no
fuse or fuse with improper rating may
cause damage to this unit or even fires.
If a proper fuse is installed and electrical
problems still occur, please contact your
local authorised service agent.
• DO NOT connect other equipments with
the car battery to avoid battery overheating.
• Please make sure all the wiring
connections & the cables of the Speakers
are well-insulated. Otherwise, this unit may
be damaged by short circuit.
• If there is no ACC available, please
connect ACC lead to the power supply with
a switch.
• If an external power amplier is connected,
please don't connect P.CONT lead to the
power lead of the external power amplier,
otherwise, electric spark or other damage
may result.
• Never ground the speaker output to
prevent the damage to the built-in power
amplier.