Operation Manual

20
Listen to Other Devices
You can connect an external audio/video device to be unit.
1. Connect the car audio to the device with the supplied AV cable.
2. Touch the upper left corner to display the main menu.
3. Touch [AV-IN1] / [AV-IN2].
4. Operated the connected the device(see the instructions manual of the device).
Tip:
If you connected the system to other audio device through the REAR OUT L/R connectot(see
“Connect wires” section), touch [AV-IN] to listen to that device.
Reset
When the unit hangs up, you can reset it.
Press RESET with a ball-point pen or similar tool.
Tip:
When the unit is reset, all the settings remain unchanged.
Remove the Unit
To repair ,replace a fuse ,or replace the unit with another car audio,remove it from
the dashboard.
1. Take off the trim plate.
2. Screw off the four screws on the left/right side of the unit.
3. Pull the unit out from the dashboard.
Replace a Fuse
If there is no power,the fuse may be damaged and need to be replaced.
1. Take out the unit from dashbpard.
2. Check the electric connection.
3. Buy a fuse that matches the voltage of the damaged fuse.
4. Replace the fuse.
User-Dened Wallpaper
1. Touch the [ ] icon on the nether left of main menu to
change wallpaper.
2. Load picture from SD Card and use it as wallpaper
If you insert the SD Card with pictures in it after your entry,
you may have to wait several seconds for the SD Card
reading. Otherwise you may use it directly.
To Select a picture in SD Card, you should touch “ Browse
SD Card” button first, then the directories and the files
will be listed. If you select a directory and then touch [ √ ]
button, you will enter the directory. If you select a picture
and then touch [ √ ] button, the picture will be loaded into
the ash and used as current wallpaper at the same time.
Touch the button below [ √ ] to go back to view the pictures in ash.
Touch the button at the right side of the display of directory to go back to the upper directory.
Other modes