Operation Manual

RMN 801BT NavigatioN MaNual
ENGLISH
After leaving the tunnel, the original map view returns.
This feature can be turned off in Settings (page 91).
6.1.4 Route calculation and recalculation
Caliber calculates the route based on your preferences:
• Route planning methods:
•
: Gives a quick route if you can travel at or near the speed
limit on all roads. Usually the best selection for fast and normal cars.
•
: Gives a route that has the smallest total distance of all
possible routes. It can be practical for slow vehicles.
•
: Gives a quick but fuel efficient route based on the fuel
consumption data given in Route settings (page 85). Travel cost and CO
2
emission calculations are estimations only. They cannot take elevations, curves
and traffic conditions into account.
•
: For vehicle types where Green routing is not available,
this method combines the benefits of Fast and Short: Caliber calculates as if it
were calculating the Fast route, but it takes other roads as well to save fuel.
•
: Results in a route with fewer turns and no difficult
manoeuvres. With this option, you can make Caliber to take, for example, the
motorway instead of a series of smaller roads or streets.
• Vehicle types:
When creating a new vehicle profile, select one of the below vehicle types. Besides the
below mentioned conditions, dimension, weight and freight hazard restrictions can also
be taken into account when planning a route.
•
:
• Manoeuvre restrictions and directional constraints are taken into account
when planning a route.
• Roads are used only if access for cars is allowed.
• Private roads and resident-only roads are used only if they are inevitable
to reach the destination.
• Walkways are excluded from routes.
•
:
• All manoeuvres are available in intersections.
• Directional constraints are taken into account the way that opposite
direction is allowed with a low speed.
• A private road is used only if the destination is there.
73