Operating instructions

T:+44 1274 394125 F: +44 1274 730960 E: techsupport@calibreuk..com 6

3.2.

Introduction

The HQView-100S units have the input connectors on one side of the housing and the output connector

as well as the communication ports on the opposite side. The keypad for controlling HQView-100S is

located on the input connectors side. The active input is indicated by their corresponding triangles lit

green.

1 – Keypad with three keys for OSD menu navigation (Menu, Down and Up) and a key for input channel

selection (Input).

With the Menu key the OSD menu is activated. The up/down keys are used for OSD menu navigation.

To exit the OSD menu or any submenu navigate go to the Exit item and press the menu key. To access

a submenu navigate to it and press the menu key. To apply a change go to the menu item, press the

menu key and make a parameter change with the up/down key. Confirm the change by pressing the

Menu key. This will also bring you back to the submenu.

By pressing the Input button multiple times the available input channels are toggled through. The active

channel is indicated by the associated green lit triangle(s).

With the following multiple key presses further functions can be applied:

Keypad unlock: Up/Down

Set output and fallback output mode to VGA: Menu/Up

Mode reset: Menu/Down

Factory reset: Menu/Up/Down