Operating instructions

© Calibre UK Limited Issue 2.10 13 August 2012, W: www.calibreuk.com
T:[phone] F: [phone] E: techsupport@calibreuk..com 11
3.3.
Main Menu
The main menu lists the input channel select item, 6 sub menus, and a menu item for automatic setup
of VGA modes. The 6 sub menus are Output, Color, Geometry, Multiple Unit, Enhancement and
System.
On each menu page an Exit menu item is available to leave the menu or submenu. The menu may also
be left by pressing the up/down key simultaneously.
Some adjustments are not applicable to all signal types or operating modes, in which case those non-
applicable functions will be ghosted and are not accessible via the menus.
All menus have a top status line and a bottom line indicating the firmware revision number. In the status
line the currently selected input channel is indicated and the detected mode is identified. The firmware
revision number displays the revision number of the bootloader behind BL, the revision number of the
firmware behind FW and the model number 325 of the unit.
Navigating the menu system or changing values is done with the up and down keys. In the following
sections the set-up method using the up and down keys is described.
To set up your HQView-325 it is recommended that you follow this procedure:
Choose the correct output mode and parameters to suit your screen or projector.
Select the correct input signal.
Set the input levels and features appropriately to optimize the appearance of your image.
Set any other parameters to suit your application.
Note: All Input parameters are specific to your chosen input channel and input signal type, they are not
global to the unit. All Output parameters are global
3.4.
Input
The list of available inputs can be scrolled through using the Up and Down keys. The new input is not
selected until the Menu key is pressed. The list of inputs are: VGA, DVI, HDMI and Test Pattern.
Test patterns can be generated by HQView-325 without needing an input connected. When Test Pattern
is selected as the input, the required test pattern can be chosen with the menu navigation up/down keys
when the OSD menu is off.
3.5. Output
This menu contains adjustments associated with setting up outputs from the unit. The items are
organized in three sub menus, Display Type, Gamma/Color/Crush and Output Config. Use the up and
down keys to scroll to the required item and press the Menu key.
3.5.1. Display Type
Settings: LCD/Plasma, Projector
The Display Type setting defaults to Projector. When set to LCD/Plasma Multiple unit configurations
with auto zoom are available, but without edge blend. Note: For HQView-325 leave the setting to
Projector mode, since for this model essentially there is no difference to LCD/Plasma mode.