Operating instructions

T:+44 1274 394125 F: +44 1274 730960 E: techsupport@calibreuk..com 12

3.5.2. Output Mode

Settings: 640x480, 800x600, 1024x768, 1280x768, 1280x800, 1280x1024, 1360x768, 1366x768,

1400x1050, 1440x900, 1600x1200, 1680x1050, 1920x1200, 480i, 576i, 480p, 576p, 1080i, 720p, 1080p

Set up the desired output resolution with output mode. The output mode setting should match the native

resolution of the imaging device to avoid double scaling.

The default output resolution as set by the factory or after a user issued factory reset is 720p.

3.5.3. Location

Settings: Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling

The image can be flipped to accommodate different projection scenarios as well as screens mounted

upside down.

3.5.4. Frame Rate

Settings: 60 Hz, 50 Hz, 48 Hz, 24 Hz, Auto

In auto mode the output frame rate follows the input frame rate as configured in the Output Config

menu. Signals with 24Hz, 25H, 48Hz, 50Hz (plus margin) input modes get special treatment, modes

with other refresh rates are displayed at 60Hz. 24Hz input modes will be output at 24Hz if the output

resolution is set to either 720p or 1080p and the Frame Rate setting in the Output Config menu includes

24Hz, otherwise it is displayed at twice the rate if the Frame Rate setting in the Output Config menu

includes 48Hz. Otherwise a 24Hz input mode is displayed at 60Hz. 48Hz input modes will be output at

48Hz if the Frame Rate setting in the Output Config menu includes 48Hz. Otherwise it is displayed at

50Hz. A 25Hz input mode is output at twice the frame rate 50Hz. An exception to the 24/25Hz input

mode treatment is if the output resolution is set to 480i or 480p. 480i and 480p are always run at 60Hz

output rate. 50Hz input modes are displayed at 50Hz output rate.

The output frame rate can also manually set to 24Hz, 48Hz, 50Hz or 60Hz if possible, i.e. such output

modes are available. Only 720p and 1080p output modes are available with 24Hz refresh rate. 480i and

480p output modes are only available at 60Hz refresh rate. For all other modes 48Hz, 50Hz and 60Hz

refresh rate is available.

3.5.5. I/O Lock

Settings: Off, Auto

If I/O Lock is switched off the output is run with a fixed refresh rate determined by the frame rate setting,

which deviates from the input refresh rate, even if both are nominally at the same rate. This causes

occasional frame dropping or repeat.

If I/O Lock is set to Auto the output refresh rate is following the input video refresh rate if locking is

possible. Locking is achieved by modulating the output clock and works if input and output refresh rate

are nominally at the same rate, e.g. when frame rate is set to 60Hz and the video input is also 60Hz. If

e.g. the video input rate is 50 Hz and the Frame rate is set to 60Hz, the output will enter free run mode.

When Frame Rate is set to Auto the matching frame rate is chosen.

The status line of the OSD window under Sync Mode indicates if the output signal is locked to the input

signal (I/O Locked) or in free run mode (Free Run).

3.5.6. Native Color Temp

Settings: 5500, 6500, 7500, 9300, 10000

Native Color Temp allows the user to select from pre-configured color temperatures to match the

display. If both Native Color Temp set here in the Output menu and Color Temp set in the Color menu

are set to the same value, no conversion is performed.