User Guide

DIAGRAM H1
REAR RADAR RECEIVER
(BEHIND BUMPER COVER)
RECEIVER
SCREWS
METAL
SUPPORT
REAR RADAR RECEIVER
The rear radar receiver can be mounted behind plastic, rubber, or fiberglass up to 1/4” thick. Do not mount
radar receiver behind metal or chromed plastic.
1. The rear radar receiver can be fastened to the vehicle using the
supplied self-tapping screws or cable ties. See DIAGRAM H1.
2. Route the rear radar receiver cable into trunk through factory
grommet.
3. If a factory grommet is not available, use the provided strain relief:
a. Choose a mounting location in the trunk compartment as close
to the radar receiver as possible.
b. Drill a 1/2” hole into the chosen location for the strain relief.
c. Install the strain relief and tighten the mounting nut securely.
d. Route the rear radar receiver cable through the strain relief,
leaving a little slack in the receiver cable.
e. Tighten the waterproof gasket nut to create a waterproof seal.
4. Connect wires per the separate enclosed block diagram sheet.
CAUTION: Do not drill into the trunk until you know what is on both sides of the drilling area. Watch for
cables, spare tires, and gas tank.
Rear Laser Defuser
License Plate Mount
1. Remove the mounting bolts and any existing frame or cover from the rear license plate. Remove license plate.
2. Position the Laser Defuser around the existing rear license plate and mount it against the factory license plate bracket.
Use the existing mounting bolts or K40 supplied nylon bolts to secure the Laser Defuser frame and license plate to
the bracket.
On vehicles that have only one set of bracket mounting holes, it is recommended that the Laser Defuser
and the license plate be bolted together to eliminate any vibration.
3. For proper performance, the Laser Defuser must be mounted completely level. Use the K40 supplied nylon nuts and
bolts to correct the mounting angle of the Laser Defuser either up or down as needed. See DIAGRAM I1.
LASER DEFUSER
FACTORY
MOUNTING
LOCATION
MOUNTING NUTS
LASER DEFUSER
FACTORY
MOUNTING
LOCATION
LASER DEFUSER
FACTORY
MOUNTING
LOCATION
On some vehicles, it may be necessary to adjust or reposition the factory license plate bracket to achieve
the required level mounting.
DIAGRAM I1
NOTE:
NOTE:
NOTE: