Installation Sheet

ManualsBrandsCalifornia Faucets ManualsShop All California FaucetsCalifornia Faucets Miramar 1.2 GPM Widespread Bathroom Faucet with Double Handles - Includes Ceramic Disc Valve

Miramar™

CF-4802 & CF-4802X

Widespread Lavatory Faucet

Installation Instructions

CF-4802_ii_120821.doc Pg 1

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.

Operating Specifications:

Recommended Supply Pressure: 20 to 70 psi

*†

Maximum Flow Rate: 1.5 gpm

* Operating pressures between hot and cold supplies should vary no more than 30 psi.

† If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (RPV).

INSTALLING SPOUT TO SINK/DECK

• Sink/Deck recommended hole size shall be Ø1-3/8”

• Attach RING (2) onto BASE (3) and slide onto

spout SHANK (1a)

• Insert spout SHANK (1a ) though sink/deck hole

• From underside, place SLOTTED WASHER (4)

onto spout SHANK (1a) and tighten SPOUT (1)

into place with NUT (5)

• Insert RUBBER WASHER (6) into TEE (7) and

attach to spout SHANK (1a)

IMPORTANT: TEE (7) should be tighten to create watertight seal

and positioned to allow ease of attachment of valve hoses

Ø1-3/8”

Summary of content (4 pages)

PAGE 1
Miramar™ CF-4802 & CF-4802X Widespread Lavatory Faucet Installation Instructions CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer. Operating Specifications: Recommended Supply Pressure: 20 to 70 psi *† Maximum Flow Rate: 1.5 gpm * † Operating pressures between hot and cold supplies should vary no more than 30 psi.
PAGE 2
• INSTALLING VALVE From underneath insert VALVE (10) though appropriate sink/deck hole IMPORTANT: VALVES (10) are labeled as follows: BLUE is COLD left turning (counter-clockwise) closed RED is HOT right-turning (clockwise) closed • Position flange NUT (9) and WASHER (8) so that VALVE (10) extends 2-5/16” above sink/deck surface • Attached RING (2) onto ESCUTCHEON (11) • Place ESCUTCHEON (11) onto VALVE (10) and secure to sink/deck surface 2-5/16” 3 INSTALLING HANDLE • Loosen SETSCREW (12c)
PAGE 3
4 INSTALLING VALVE HOSES • Attach small hose NUT (13a) to spout TEE (7a) • Attach large hose NUT (13b) to valve side OUTLET (10b) • Repeat on other side valve 5 • INSTALLING DRAIN Slide white foam WASHER (14) up under flange of BODY (15) - or - • Apply thin film of Silicon® sealant (or equivalent – DO NOT use petroleum-based sealant as this WILL void finish warranty) to underside of flange on BODY (15) • Insert BODY (15) down through sink drain hole • From underside, slide MACH-WASHER (16) an
PAGE 4
6 INSTALLING SUPPLIES LINES IMPORTANT: Prior to attachment, flush supply lines to remove debris that may cause damage or malfunction to valve cartridge.