User guide

COLD
COLD
COLD
COLD
COLD
INSTALLATION
INSTRUCTIONS
SINGLE HOLE, BAR FAUCET
IMPORTANT
All California Faucets products are engineered to provide quality performance provided they
are installed and operated properly. To fully enjoy the comfort, safety, and reliability of your new
Single Hole Bar Faucet, please follow the instructions below.
6109
***NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
1
-Screw flex lines into body,
(one long & one short)
tighten with adjustable wrench
until stop. Do not over tighten.
-Make sure sealing washer
is fitted into base of body.
-Install faucet assembly, inserting
flex lines and mounting rod through
hole in sink or countertop.
-Center faucet on hole.
-Install horseshoe bracket
and rubber washer.
Fig. 1
Flex Lines
(one long &
one short)
Fig. 2
Fig. 3
Meets A112.18.1 - 2.2 gpm/8.31 L/min.
Body
Fig. 5Fig. 4
Rubber Washer
Horseshoe Bracket
Handle
Aerator
Spout
Spout
Base
Front View
Side View
2
43
Sink/Countertop
Hole
Install flex lines: Install assembly:
Sealing
Washer
Flex Lines
Mounting
Rod
-Screw on brass nut to mounting rod.
-Hand-tighten and align faucet, then
tighten brass nut firmly with a deep
socket or adjustable wrench.
Mounting
Rod
Brass
Nut
Install washers:
Tighten to surface:
Body
Recommended
Hole Size:
1 3/8" Min.
1 1/2" Max.
Tel: [phone]
Fax: [phone]
Toll Free: 800-822-8855
www.calfaucets.com
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
R
Ref. 6109-INSTL
(V 01) 08/17/06
Continued