Instructions / Assembly

HANDLE EXTENSION & WHEEL TRANSPORT KIT
Evergreen Turf Equipment • 1028 4
th
St. SW, Bldg. A • Auburn, Washington 98001 • 253.333.3345 • CalTrimmer.com
HANDLE EXTENSION KIT (#4012561)
KIT COMPONENTS
 Middle handle section (1)
 Engine Brake cable w/ cover (1)
 Throttle cable (1 – Honda Engine only)
 Knob Assembly (2)
 Cable tie straps (2)
INSTALLATION STEPS & NOTES
STEP 1 - Remove the engine stop
lever from the upper handle – by
pulling one side out of the
mounting hole. Also remove the
inner cable end.
STEP 2 - Remove the engine stop
cable adjuster from the upper
handle (throttle also on Honda)
STEP 3 - Remove the inner end of the engine stop cable
from the engine brake lever.
STEP 4 - Remove the outer cable from the bracket – by
using pliers to compress the locking tabs while pulling.
STEP 5 - Install the kit’s (longer) cable end by inserting the
end onto the engine brake lever, then inserting the outer
cable into the bracket. Install the additional handle
section, secure with knobs, then re-install the engine stop
cable adjuster and lever.
WHEEL TRANSPORT KIT (#4041500)
INSTALLATION STEPS & NOTES
STEP 1 - With the frame positioned behind the unit as
shown above, insert the mounting post into the right
side handle hole first, followed by the spring-loaded
post in the left side.
STEP 2 - Once
the frame is
installed,
place your
right foot
behind the
wheel, pull up
slightly on the
top handle.
This will raise
the back of
the deck off the ground. At the same time, pull the top
handle back keeping the rear part of the deck only a
couple inches off the ground.
STEP 3 - Continue this movement until the rear part of
the deck is resting on the wheel kit base. Tilting the top
handle down will raise the front of the hover mower
and allow you to transport it.