User's Manual

- 2 -
ALIMENTATION ÉLECTRIQUE
• Connectez le cordon d’alimentation uniquement à uneprise d’alimentation CA conforme aux spécifi cations GigaSpire.
• Ne modifi ez jamais le cordon d’alimentation CA. Si nécessaire, faites installer la bonne prise par un électricien qualifi é ou appelez votre
fournisseur de servicepour obtenir de l’aide.
• Pour réduire le risque d’endommager le cordon électrique, retirez-le de la prise en le tenant par la fi che moulée de l’adaptateur secteur
plutôt que par le cordon.
• Assurez-vous que le cordon est positionné de sorte qu’il ne puisse pas marcher dessus, trébucher ou subir
• d’autres dommages ou contraintes.
!
Attention ! N’utilisez pas d’autre adaptateursecteur que celui qui accompagne cet appareil ou une
alimentation électrique autre que celle identifi ée dans la liste ci-dessous. L’utilisation d’un autre adap-
tateur pourrait endommager l’appareil. Pour éviter les chocs électriques, n’ouvrez pas le couvercle.
L’adaptateur électrique suivant est qualifi é pour être utilisé avec le GigaSpire.
L’adaptateur électrique suivant est qualifi é
pour être utilisé avec le GigaSpire
Ce GigaSpire doit être alimenté par un adapteur
Frecom F60-120500SPA ou une source d’alimentation équivalente certifi ée UL LPS de capacité:
Entree: Input: 100-240 VAC, 50-60 Hz, 1.6A Max,
Sortie: Valeur nominale 12 VDC, 5A Max, 60W Max
Federal Communications Commission (FCC)
INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
CAUTION: Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment.
CAUTION: This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter except
in accordance with FCC multi-transmitter product procedures.
ADDITIONAL CONSIDERATIONS
The country code selection is for non-US models only and is not available on any US models. Per FCC regulations, all Wi-Fi products
marketed in the US must be fi xed to US operational channels only.
RF FREQUENCY REQUIREMENTS
This device is for indoor use only when using all channels in the 5.150 GHz - 5.250 GHz and 5.725 GHz - 5.850 GHz frequency range. High
power radars are allocated as primary users of the 5.250 GHz - 5.350 GHz and 5.470 GHz - 5.725 GHz bands. These radar stations can
cause interference with and/or damage this device. It is restricted to indoor environment only.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with a minimum distance of 27cm between the radiator & your body.
Industry Canada Requirements - English
The manufacturer declares that this product is in conformity with the requirements and other relevant provisions of the following Canadian
standards:
• CAN ICES-3 (B)/NMB-3(B)
• This device complies with ISED’s licence-exempt RSS standards. Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION:
(i) The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems;
(ii) The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specifi ed for
point-to-point and non-point-to-point operation as appropriate.
(iii) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5650-5850
MHz and that these radars could cause interference and/or damage to LE-LAN devices.