User manual

Placing a call with voice dialing (if supported by phone). With no call present,

press the multifunction button and speak the name of the person you want to

call. For the best results, record the voice tags for voice dialing using the Onyx

headset.

Answering/Ending a call. When the headset rings, press the multifunction button

to accept an incoming call. If a call is already present, the rst call will be placed

on hold. The calls can then be swapped by pressing the multifunction button.

While on a single or conference call, press the multifunction button to end the

call.

Muting the microphone. While on a single call, press and hold the multifunction

button to mute your microphone. Press and hold the multifunction button again

to unmute.

Rejecting a call. Pressing and holding the multifunction button on an incoming

call will reject the call. If on a call with a call on hold, pressing and holding the

multifunction button will hang up the active call.

Adjusting the speaker volume. To increase or decrease the speaker volume, press

the power & volume control button up or down. Note: Volume control directions

are opposite when the headset is in the left ear.

Operation

callpod