User's Manual

ManualsBrandsCalsonic Kansei ManualsElectronicsVehicle Door Lock Transceiver

USER OPERATION INSTRUCTION (DRAFT)

KEY FREE SYSTEM

The key free uses coded radio signals to communicate with the vehicle.

When the key free is near the vehicle such as in your pocket or purse.

It allows the vehicle to be locked unlocked, or started without inserting the ignition

Key. It is also possible to use the control entry function.

△ CAUTION

・

Be sure to carry the key free with you.

・ Do not leave the vehicle with the key free inside.

・

The key free may not function correctly depending on the environment or operating

conditions, if you do not use it correctly.

・The key free transmits faint radio waves.

・ When there are strong signals coming from a television tower, power station or

a cellular phone with you.

・

When the key free is in contact with or covered by a metallic material.

・ When radio wave-type remote control entry is used nearby.

・ When the key free is placed near an electric appliance such as a personal

Computer.

・ The key free continually consumes battery power as the key receives a signal to

communicate with the vehicles.

・ Battery life is about 2 years, although it varies depending on the operating

conditions. When the battery of the key free is low，

If the battery runs down, replace it with a new one.

・ If the key free receive strong signal over an extended period of time the

Battery could quickly run down. Do not place the key free near an electric

appliance such as a television set or personal computer.

1. KEY FREE OPERATION

You can lock or unlock the doors without taking the key out from your pocket or

purse. When you carry the key free with you. You can lock or unlock all door by

pushing the door handle request switch or back door handle request switch within

the range of operation.

Summary of content (6 pages)

PAGE 1
USER OPERATION INSTRUCTION (DRAFT) KEY FREE SYSTEM The key free uses coded radio signals to communicate with the vehicle. When the key free is near the vehicle such as in your pocket or purse. It allows the vehicle to be locked unlocked, or started without inserting the ignition Key. It is also possible to use the control entry function. △ CAUTION ・ Be sure to carry the key free with you. ・ Do not leave the vehicle with the key free inside.
PAGE 2
. Locking doors 1. Turn the ignition knob to the LOCK position and remove the ignition key if any metal key is in the ignition knob. 2. Close all the doors. 3. Push any front door or the back door handle request switch while carrying the key free with you 4. All the door and back door will lock. 3.Unlocking doors 1. Push the door handle request switch once Drivers side: ・The driver door unlock Front passenger side or back door. ・Only corresponding door unlocks. 4.
PAGE 3
1 Securely depress the brake pedal. 2.Slowly push the ignition knob in/ When the intelligent key warning light in the instrument (meter) panel comes on in blue, the ignition knob can be turned. 3.Turn the ignition knob to START and the engine will be started. 2. When the engine starts, release the ignition knob. △ WARNING Do not start the engine from outside the vehicle through the window. Doing so could lead an accident and injury. Be sure to sit in the drivers seat to use the key.
PAGE 4
KEY FREE OPERATING RANGE The key free function can be used only when you carry the key with you and operate as specified in the operating range inside or outside the vehicle. When the key free battery runs down or where there are strong radio waves or noise , the operating range may be narrower or the key may be inoperative. Operating range of the door lock/unlock function The outside sensors are in the front door handle and the back door handle.
PAGE 5
Using the panic alarm If you are near your vehicle and feel threatened, you may activate the alarm to call attention as follows. 1. Push the PANIC button on the intelligent key for longer 0.5 second with the metal key removed from the ignition key cylinder or the ignition knob pushed in. 2. The theft warning alarm and headlights with stay on for 30 second. 3.
PAGE 6
FCC,IC Notice. Changes or modifications not expressly approved by the manufacturer for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules and Regulation and the Standard RSS-210 of Industry Canada.