Quick Reference Guide

secret▲
All rights reserved.No spreading abroad without permission of Caltta.
17

UART Baud Rate
This parameter sets the baud rate of the interface on the radio accessory when the
radio communicates with a third-party device through the serial port.
Default: 115200, Range：300~600000.

Designated Power-on Zone/Channel
This option allows users to set a power-on channel. When the radio is turned on, it
will switch to this channel. If the user does not designate a power-on channel, the radio
will enter the channel last used when it is turned on.
Default: off, Range: All available channels can be designated as the power-on
channel.

High Tx Power
This option allows users to set the high Tx power value of the mobile radio or repeater.
This is a radio-wide feature.
Default: 50W, Range: 10 ~ 50W

Low Tx Power
This option allows users to set the low Tx power value of the mobile radio or repeater.
This is a radio-wide feature.
Default: 1W, Range: 1 ~ 10W
Microphone

Internal Mic Gain
This option allows users to set the internal microphone Gain.
Default: 3.0, Range: 2.0 ~ 10.0.

External Mic Gain
This option allows users to set the external microphone Gain.
Default: 3.0, Range: 2.0 ~ 10.0
Priority Control

Phone Priority
This parameter allows you to enable and disable the Phone Priority feature.After the
Phone Priority feature is enabled, if the repeater receives phone request from mobile
phone or radio during repeating or local PTT transmitting, it will respond to the phone
request first.
During a phone call, the Repeat Request Priority is set to First Come First Send;
during a phone call or there is a phone request, the Path Priority is set to Repeat Request;