Retail Locations New York, NY 10011 16 W. 19th St. 212-989-8500 Cambridge, MA 02141 65 Bent St. 617-576-2600 Philadelphia, PA 19147 1400 S. Columbus Blvd. 215-399-2155 Bensenville, IL 60106 890 Supreme Dr. 630-860-7458 Chicago, IL 60622 1111 N. Cherry Ave. 312-440-4920 San Francisco, CA 94110 2001 Bryant St. 415-643-9275 Santa Barbara, CA 93101 228 E. Cota St. 805-965-7053 Santa Ana, CA 92705 1430 S. Village Way, Suite A 714-285-0143 San Diego, CA 92025 830 W.
Table of Contents Description Introduction Page Introduction & Safety Notes 3 Control Panel Guide 4 Connecting and Using Your Travelite 5 Flash Power Control 6 Modeling Lamp Controls 6 Synchronization 6 Changing the Modeling Lamp 7 Changing the Fuse 7 Changing the Flash Tube 7 Mounting and Removing Reflectors 7 Travelite Accessories Specifications 8–9 10 – 11 Dear Valued Customer, Thank you for choosing the Calumet Travelite professional flash system.
Control Panel Guide Connecting and Using Your Travelite Rear Control Panel Operating Your Travelite Carry handle The Calumet Travelite may be operated either on an AC supply or with a Calumet Travel-Pak For AC operation, the AC switch (page 4) should be in the upper position I. For battery operation the switch should be in the lower position II. AC / Battery Power Select Photocell On/Off The center position is off. NOTE: When operated from a battery source, the modeling functions are not available.
Flash Power Control The flash-power output level is variable over 5-stops, from full to 1/32 power. The maximum power available depends upon the model (See specification table) and is denoted by the number 6 on the control panel. The power settings are denoted in 1⁄3-stops. The numeric divisions indicate full-stop divisions. When switched on from either AC or battery supply, the unit will charge.
Accessories Accessories LiteLink Radio Trigger System Reflectors Calumet’s light-control reflectors are built to withstand many years of rigorous, daily use. They feature extremely strong housing and steel bayonet-type mounts for quick, positive mounting. The inner steel ring provides additional durability for frequent reflector changes. From studio sets to location sites, Calumet’s comprehensive system of accessories can handle any situation or assignment.
Specifications Travelite Specifications Comparison Chart Travelite 375 Travelite 750 375w/s 750w/s 5V 5V Flash Color Temperature 5600 K ±300 K 5600 K ±300 K Circuit Protection 115V - 10A (T) 115V - 10A (T) 95-130V AC 60Hz 95-130V AC 60 Hz Voltage Stabilization ±1% ±1% Guide Number 220 350 1.7 sec. 2.1 sec.