OPERATORS MANUAL for Electric Pressure Washers Basic Hand Carry Hand Carry 1500A Basic Cart C1000E Cart Electric Cart Electric
Thank You... for selecting our products. Our personnel have proudly made every effort to ensure that your new Pressure Washer is of the quality that you expect. But things do occasionally go wrong. This is why every pressure washer is covered by a limited warranty. Among other things this warranty provides for the replacement of parts found to be defective during the operation of your new pressure washer. Please note that the owner/operator has certain obligations under the terms of the warranty.
WARNING The following warnings must be followed, Failure to follow these warnings could result in serious personal injury or death! Never allow children or untrained personnel to operate machinery. Electrical equipment can cause shock and sparks. Do not bypass or remove the grounding prong in any electrical plug. Keep electrical plugs, connections and cords out of water and moisture. Refer to instructions prior to equipment operation. Disconnect from power source before servicing.
Initial setup and operation of your new pressure washer Inspection for freight damage. When you receive your pressure washer be sure you check for concealed freight damage. Any damage should be noted with the delivering carrier. If you have any questions related to freight call the 800 number listed in the front of the manual. Inspection Check all oil levels in the pump or engine if applicable. Failure to check all levels will result in of oil levels equipment damage.
During Operation The pressure was set at the factory during the testing procedure, no adjustments to the machine should be required for operation. During operation do not leave the machine running for more than 2 minutes without the trigger gun being pulled. Although your machine has a by-pass valve on it and may have a thermal relief system, this can cause extensive pump damage. If machine will not be discharging water for more than 2 minutes, shut the machine off.
Shut down procedure Storage 1. Turn off the power switch on the pressure washer. 2. Relieve pressure on line by pulling trigger gun. 3. Shut off water supply and disconnect garden hose. 4. Be sure to check for water leaks or oil leaks that should be repaired before the next operation. 5. If you are going to store the machine for extended period of times in cold climates be sure to antifreeze the equipment.
Two Piece Gun/Wand used on smaller electric units(uses orifices) Orifice Size Machine Specifications #3.5 1450 PSI @ 2.0-2.2 GPM 2500 PSI @ 3.0-3.5 GPM 1000 PSI @ 2.0-2.2 GPM 3000 PSI @ 4.0-4.5 GPM 1500 PSI @ 3.0-3.5 GPM 2000 PSI @ 4.0-4.5 GPM #4 #5 #6 Gun/Wand used on large electric units(uses either Multi-Reg or Q Meg Tip) Q-Meg Tips Multi-Reg Tip Q-Meg Size #3.5 Machine Specifications 1450 PSI @ 2.0-2.2 GPM 2500 PSI @ 3.0-3.5 GPM 1000 PSI @ 2.0-2.2 GPM 3000 PSI @ 4.0-4.5 GPM 1500 PSI @ 3.0-3.