OPERATORS MANUAL for GAS & DIESEL POWERED PRESSURE WASHERS Hand Carry Gas Cart Gas Cart Gas Basic Cart Gas Skid Diesel Cart Diesel 510504.
Thank You... .....for selecting our products. Our personnel have proudly made every effort to ensure that your new Pressure Washer is of the quality that you expect. But things do occasionally go wrong. This is why every pressure washer is covered by a limited warranty. Among other things this warranty provides for the replacement of parts found to be defective during the operation of your new pressure washer. Please note that the owner/operator has certain obligations under the terms of the warranty.
WARNING The following warnings must be followed, Failure to follow these warnings could result in serious personal injury or death! Never allow children or untrained personnel to operate machinery. CAUTION Gun kicks back--hold with both hands. Wear protective clothing and face shield. Do not direct water stream toward self or others. Do not spray electriical apparatus. High pressure water can cause death or serious injury. High pressure fluid can create a high pressure stream or ruptured vessel.
AVERTISSEMENT Il faut se conformer aux avertissements suivants pour éviter de courir le risque de se blesser gravement ou de mourir ! Ne jamais permettre aux enfants ou à un personnel non formé de faire fonctionner les machines. ATTENTION - LE PISTOLET S’ÉCHAPPE - TENEZ-LE À DEUX MAINS Eau à haute température. Porter des vêtements de protection et un masque de sécurité. Ne pas diriger le jet d’eau vers soi ou vers les autres. Ne pas arroser des appareils électriques.
Initial setup and operation of your new pressure washer Inspection for freight damage. When you receive your pressure washer be sure you check for concealed freight damage. Any damage should be noted with the delivering carrier. If you have any questions related to freight call the 800 number listed in the front of the manual. Inspection Check all oil levels in the pump or engine if applicable. Failure to check all levels will result in of oil levels equipment damage.
During Operation The pressure was set at the factory during the testing procedure, no adjustments to the machine should be required for operation. During operation do not leave the machine running for more than 2 minutes without the trigger gun being pulled. Although your machine has a by-pass valve on it and may have a thermal relief system, this can cause extensive pump damage. If machine will not be discharging water for more than 2 minutes, shut the machine off.
Shut down procedure Pump The pump oil should be changed after the first 50 hours of operation, then every year for average service or more frequently for extensive use or hostile environments {dusty or high moisture} Engine If the engine is to be stored for an extended length of time, a fuel stabilizer is highly recommended. Failure to use a fuel stabilizer may result in varnishing in the carburetor or injectors and will require servicing to make the engine run.
Two Piece Gun/Wand used on smaller units(uses orifices) Orifice Size #3.5 #4 #5 #6 Machine Specifications 1450 PSI @ 2.0-2.2 GPM 2500 PSI @ 3.0-3.5 GPM 1000 PSI @ 2.0-2.2 GPM 3000 PSI @ 4.0-4.5 GPM 1500 PSI @ 3.0-3.5 GPM 2000 PSI @ 4.0-4.5 GPM Gun/Wand used on large gas and diesel units (uses either Multi-Reg or Q Meg Tip) Q Meg Tips Multi-Reg Tip Q Meg Size #3.5 #4 #5 #6 Machine Specifications 1450 PSI @ 2.0-2.2 GPM 2500 PSI @ 3.0-3.5 GPM 1000 PSI @ 2.0-2.2 GPM 3000 PSI @ 4.0-4.5 GPM 1500 PSI @ 3.0-3.
