User's Manual
Table Of Contents
- 1 About This User Guide
- 2 Avoiding Hazards
- Getting Started
- For Your Safety
- 3.2 Welcome
- 3.3 Product Description
- 3.4 Warranty
- 4 Product Architecture
- 5 General Considerations
- 5.1 Spectrum Planning
- 5.2 Introducing the Time Division Duplex (TDD) Synchronization Feature
- 5.3 Region Codes
- 5.4 Operational Restrictions
- 5.5 2.5GHz Specific Frequency Planning Considerations
- 5.6 5.4GHz Specific Frequency Planning Considerations
- 5.7 5.8GHz Specific Frequency Planning Considerations
- 5.8 Distance
- 5.9 Networking Information
- 5.10 Lightning Protection
- 5.11 Electrical Requirements
- 6 Site Planning
- 6.1 Site Selection Criteria
- 6.1.1 ODU Site Selection
- 6.1.2 PTP 600 Series Bridge PIDU Plus Site Selection
- 6.1.3 Path Loss Considerations
- 6.1.4 Definitions
- 6.1.5 2.5 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1.6 5.4 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1.7 5.8 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1 Site Selection Criteria
- 7 Installation
- 7.1 Preparation
- 7.2 Installation Procedure
- 7.3 Tools Required
- 7.4 Installation Support
- 7.5 Legal Disclaimer
- 7.6 Mounting the ODUs
- 7.7 Connecting Up
- 7.7.1 Preparing The PIDU Plus To ODU Cable
- 7.7.2 Making the Connections at the ODU
- 7.7.3 Making the PTP 600 Series Bridge PIDU Plus Connection At The ODU
- 7.7.4 Routing the Cable
- 7.7.5 Fitting A Surge Arrestor
- 7.7.6 Grounding the Installation
- 7.7.7 Making the ODU Connection at the PTP 600 Series Bridge PIDU Plus
- 7.7.8 Making the Network Connection at The PIDU Plus – PTP 600 Series Bridge
- 7.7.9 Mounting the PTP 600 Series Bridge PIDU Plus
- 7.7.10 Powering Up
- 7.7.11 Aligning the PTP 600 Series Bridge ODUs
- 8 Web Page Reference
- 8.1 Home Page – PTP 600 Series Bridge
- 8.2 Systems Status Page
- 8.3 System Administration Pages
- 8.3.1 System Configuration
- 8.3.2 Statistics Page
- 8.3.3 Detailed Counters Page
- 8.3.4 Install Pages
- 8.3.5 Graphical Install
- 8.3.6 Software Upgrade
- 8.3.7 Spectrum Management
- 8.3.7.1 Wireless Channels
- 8.3.7.2 Spectrum Management Measurements
- 8.3.7.3 Measurement Analysis
- 8.3.7.4 The Spectrum Management Master / Slave Relationship
- 8.3.7.5 Spectrum Management Configuration
- 8.3.7.6 Barring Channels
- 8.3.7.7 Local and Peer Channel Spectrum Graphics
- 8.3.7.8 Active Channel History
- 8.3.7.9 Viewing Historic Spectrum Management Metrics
- 8.3.8 Spectrum Management (Fixed Frequency and WIMAX)
- 8.3.9 Spectrum Management Control - With Operational Restrictions
- 8.3.10 Spectrum Management – Example of 2.5 GHz Product variant
- 8.3.11 Remote Management Page
- 8.3.12 Diagnostics
- 8.3.13 Change System Administration Password
- 8.3.14 License Key
- 8.3.15 Properties
- 8.3.16 Reboot
- 9 Recovery Mode
- 10 Fault Finding
- 11 Lightning Protection
- 12 Wind Loading
- 13 PTP 600 Series Bridge – Connectorized Model
- 13.1 Scope
- 13.2 Product Description
- 13.3 Software/Features
- 13.4 Deployment Considerations
- 13.5 Link Budget
- 13.6 Regulatory Issues
- 13.7 Antennas for USA / Canada
- 13.8 Installation
- 13.8.1 Antenna Choice
- 13.8.2 Cables and Connectors
- 13.8.3 Tools
- 13.8.4 Miscellaneous supplies
- 13.8.5 Mounting the Connectorized 600 Series Bridge
- 13.8.6 Mounting the antennas
- 13.8.7 Alignment Process
- 13.8.8 Aligning Dual Polar Antennas
- 13.8.9 Aligning Separate Antennas
- 13.8.10 Completing the Installation
- 13.8.11 Antenna Cable Fixing
- 13.8.12 Antenna Connection Weatherproofing
- 13.9 Additional Lightning Protection
- 14 TDD Synchronization Configuration and Installation Guide
- 15 E1/T1 Installation Guide
- 16 Lightning Protection
- 17 Data Rate Calculations
- 18 AES Encryption Upgrade
- 19 Legal and Regulatory Notices
- 20 Glossary
- 21 FAQs
- 22 Index Alar
12
178H13.8.5 Mounting the Connectorized 600 Series Bridge ................................................................. 671H199
179H13.8.6 Mounting the antennas........................................................................................................ 672H199
180H13.8.7 Alignment Process .............................................................................................................. 673H200
181H13.8.8 Aligning Dual Polar Antennas .............................................................................................674H200
182H13.8.9 Aligning Separate Antennas................................................................................................ 675H200
183H13.8.10 Completing the Installation.................................................................................................. 676H201
184H13.8.11 Antenna Cable Fixing.......................................................................................................... 677H201
185H13.8.12 Antenna Connection Weatherproofing................................................................................ 678H201
186H13.9 Additional Lightning Protection............................................................................................ 679H203
187H13.9.1 ODU Mounted Outdoors ..................................................................................................... 680H203
188H13.9.2 ODU Mounted Indoors ........................................................................................................ 681H204
189H14 TDD Synchronization Configuration and Installation Guide ........................................682H205
190H14.1 Introduction.......................................................................................................................... 683H205
191H14.2 TDD Synchronization Installation and Wiring Guidelines.................................................... 684H206
192H14.2.1 Installing the Recommended GPS Synchronization Kit ...................................................... 685H206
193H14.3 Configuring the TDD Synchronization Feature ................................................................... 686H209
194H14.3.1 TDD Synchronization Enable .............................................................................................. 687H209
195H14.3.2 TDD Synchronization Configuration Menu.......................................................................... 688H210
196H14.3.2.1 TDD Synchronization Configuration – Expert Mode ........................................................... 689H214
197H14.3.2.2 Confirm Settings and Reboot ODU ..................................................................................... 690H218
198H15 E1/T1 Installation Guide ...................................................................................................691H220
199H15.1 Preparing the PTP 600 Series Bridge E1/T1 Cable............................................................ 692H220
200H15.2 Making the Connection at the ODU .................................................................................... 693H221
201H15.3 Routing the Cable................................................................................................................ 694H224
202H15.4 Fitting a Surge Arrestor ....................................................................................................... 695H224
203H15.5 Customer Cable Termination .............................................................................................. 696H224
204H16 Lightning Protection.........................................................................................................697H227
205H16.1 Overview ............................................................................................................................. 698H227
206H16.2 Recommended Additional Components for E1/T1 Installation. .......................................... 699H227
207H16.3 Surge Arrestor Wiring.......................................................................................................... 700H230
208H16.4 Testing Your Installation...................................................................................................... 701H232
209H16.4.1 Pre-Power Testing............................................................................................................... 702H232
210H17 Data Rate Calculations .....................................................................................................703H234
211H18 AES Encryption Upgrade .................................................................................................704H241
212H18.1 Configuring Link Encryption ................................................................................................ 705H241
213H18.2 Configuring Link Encryption ................................................................................................ 706H241