User's Manual
Table Of Contents
- 1 About This User Guide
- 2 Avoiding Hazards
- Getting Started
- For Your Safety
- 3.2 Welcome
- 3.3 Product Description
- 3.4 Warranty
- 4 Product Architecture
- 5 General Considerations
- 5.1 Spectrum Planning
- 5.2 Introducing the Time Division Duplex (TDD) Synchronization Feature
- 5.3 Region Codes
- 5.4 Operational Restrictions
- 5.5 2.5GHz Specific Frequency Planning Considerations
- 5.6 5.4GHz Specific Frequency Planning Considerations
- 5.7 5.8GHz Specific Frequency Planning Considerations
- 5.8 Distance
- 5.9 Networking Information
- 5.10 Lightning Protection
- 5.11 Electrical Requirements
- 6 Site Planning
- 6.1 Site Selection Criteria
- 6.1.1 ODU Site Selection
- 6.1.2 PTP 600 Series Bridge PIDU Plus Site Selection
- 6.1.3 Path Loss Considerations
- 6.1.4 Definitions
- 6.1.5 2.5 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1.6 5.4 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1.7 5.8 GHz Product Variant - Receive Sensitivity, Link Loss, Output Power and Threshold Vs Modulation Mode
- 6.1 Site Selection Criteria
- 7 Installation
- 7.1 Preparation
- 7.2 Installation Procedure
- 7.3 Tools Required
- 7.4 Installation Support
- 7.5 Legal Disclaimer
- 7.6 Mounting the ODUs
- 7.7 Connecting Up
- 7.7.1 Preparing The PIDU Plus To ODU Cable
- 7.7.2 Making the Connections at the ODU
- 7.7.3 Making the PTP 600 Series Bridge PIDU Plus Connection At The ODU
- 7.7.4 Routing the Cable
- 7.7.5 Fitting A Surge Arrestor
- 7.7.6 Grounding the Installation
- 7.7.7 Making the ODU Connection at the PTP 600 Series Bridge PIDU Plus
- 7.7.8 Making the Network Connection at The PIDU Plus – PTP 600 Series Bridge
- 7.7.9 Mounting the PTP 600 Series Bridge PIDU Plus
- 7.7.10 Powering Up
- 7.7.11 Aligning the PTP 600 Series Bridge ODUs
- 8 Web Page Reference
- 8.1 Home Page – PTP 600 Series Bridge
- 8.2 Systems Status Page
- 8.3 System Administration Pages
- 8.3.1 System Configuration
- 8.3.2 Statistics Page
- 8.3.3 Detailed Counters Page
- 8.3.4 Install Pages
- 8.3.5 Graphical Install
- 8.3.6 Software Upgrade
- 8.3.7 Spectrum Management
- 8.3.7.1 Wireless Channels
- 8.3.7.2 Spectrum Management Measurements
- 8.3.7.3 Measurement Analysis
- 8.3.7.4 The Spectrum Management Master / Slave Relationship
- 8.3.7.5 Spectrum Management Configuration
- 8.3.7.6 Barring Channels
- 8.3.7.7 Local and Peer Channel Spectrum Graphics
- 8.3.7.8 Active Channel History
- 8.3.7.9 Viewing Historic Spectrum Management Metrics
- 8.3.8 Spectrum Management (Fixed Frequency and WIMAX)
- 8.3.9 Spectrum Management Control - With Operational Restrictions
- 8.3.10 Spectrum Management – Example of 2.5 GHz Product variant
- 8.3.11 Remote Management Page
- 8.3.12 Diagnostics
- 8.3.13 Change System Administration Password
- 8.3.14 License Key
- 8.3.15 Properties
- 8.3.16 Reboot
- 9 Recovery Mode
- 10 Fault Finding
- 11 Lightning Protection
- 12 Wind Loading
- 13 PTP 600 Series Bridge – Connectorized Model
- 13.1 Scope
- 13.2 Product Description
- 13.3 Software/Features
- 13.4 Deployment Considerations
- 13.5 Link Budget
- 13.6 Regulatory Issues
- 13.7 Antennas for USA / Canada
- 13.8 Installation
- 13.8.1 Antenna Choice
- 13.8.2 Cables and Connectors
- 13.8.3 Tools
- 13.8.4 Miscellaneous supplies
- 13.8.5 Mounting the Connectorized 600 Series Bridge
- 13.8.6 Mounting the antennas
- 13.8.7 Alignment Process
- 13.8.8 Aligning Dual Polar Antennas
- 13.8.9 Aligning Separate Antennas
- 13.8.10 Completing the Installation
- 13.8.11 Antenna Cable Fixing
- 13.8.12 Antenna Connection Weatherproofing
- 13.9 Additional Lightning Protection
- 14 TDD Synchronization Configuration and Installation Guide
- 15 E1/T1 Installation Guide
- 16 Lightning Protection
- 17 Data Rate Calculations
- 18 AES Encryption Upgrade
- 19 Legal and Regulatory Notices
- 20 Glossary
- 21 FAQs
- 22 Index Alar
15
List of Figures
261HFigure 1 - Typical PTP 600 Series Bridge Deployment................................................................... 754H31
262HFigure 2 - Mod Record Label................................................................................................................ 755H32
263HFigure 3 – PTP 600 Series Bridge Outdoor Unit (ODU)....................................................................... 756H33
264HFigure 4 - Power Indoor Unit (PIDU Plus) – PTP 600 Series............................................................... 757H34
265H Figure 5 – PIDU Plus Recovery Switch Location ................................................................................. 758H34
266HFigure 6 – PTP 600 Series Bridge PIDU Plus Power Input.................................................................. 759H35
267HFigure 7 – PTP 600 Series Bridge PIDU Plus to ODU Cable Length Graph ....................................... 760H36
268HFigure 8 - External DC Supply Only ..................................................................................................... 761H36
269HFigure 9 - External DC Supply and AC Supply..................................................................................... 762H37
270HFigure 10 - External DC Supply and Redundant AC Supply................................................................ 763H37
271HFigure 11 - Remote LED and Recovery Switch Wiring ........................................................................ 764H38
272HFigure 12 – PTP 600 Series Bridge Layer Diagram ............................................................................. 765H42
273HFigure 13 - Co-location of Links Interference Problem - A Simple Example ........................................ 766H45
274HFigure 14 - Co-location of Links Interference Problem - TxRx Timing Diagram................................... 767H46
275HFigure 15 - Co-location of Links Interference Problem - Solution to the Simple Example ................... 768H46
276HFigure 16 - 5.8 GHz UK RTTT Channel Avoidance – 30 MHz Channel Bandwidth Only .................... 769H51
277HFigure 17 - 2.5 GHz BRS Band Channel Assignments ........................................................................ 770H54
278HFigure 18 - 5.4 GHz Available Spectrum Settings - 30 MHz Channel Bandwidth................................ 771H55
279HFigure 19 - 5.4 GHz Available Spectrum Settings - 15 MHz Channel Bandwidth................................ 772H55
280HFigure 20 - 5.4 GHz Available Spectrum Settings - 10 MHz Channel Bandwidth................................ 773H56
281HFigure 21 - 5.4 GHz Available Spectrum Settings - 5 MHz Channel Bandwidth.................................. 774H56
282HFigure 22 - 5.8 GHz Available Spectrum Settings – 30 MHz Channel Bandwidth............................... 775H57
283HFigure 23 - 5.8 GHz Available Spectrum Settings - 15 MHz Channel Bandwidth................................ 776H58
284HFigure 24 - 5.8 GHz Available Spectrum Settings - 10 MHz Channel Bandwidth................................ 777H58
285HFigure 25 - 5.8 GHz Available Spectrum Settings - 5 MHz Channel Bandwidth.................................. 778H59
286HFigure 26 - 5.8 GHz Band Edge TX Power Reduction (Region Code 1 Only) – 30 MHz Channel
Bandwidth Operation.....................................................................................................................
779H60
287HFigure 27 - Mounting to pole diameters 25mm (1”) to 50mm (2”) ........................................................ 780H69
288HFigure 28 - Integral Safety Loop ........................................................................................................... 781H69
289HFigure 29 - Completed ODU connector................................................................................................ 782H71
290HFigure 30 - RJ45 Pin Connection (T568B Color Coding) ..................................................................... 783H71
291HFigure 31 – PTP 600 Series Bridge PIDU Plus Connection................................................................. 784H72
292HFigure 32 - Disconnecting the ODU...................................................................................................... 785H74
293HFigure 33 - Making the Network Connection at the PIDU Plus ............................................................ 786H76
294HFigure 34 – PTP 600 Series PIDU Plus Drip Loop Configuration ........................................................ 787H78