User's Guide Part 1
Table Of Contents
- Cambium PTP 700 Series User Guide
- Contents
- About This User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Important regulatory information
- Radar avoidance
- USA and Canada specific information
- Renseignements specifiques aux USA et au Canada
- EU Declaration of Conformity
- Application firmware
- Specific expertise and training for professional installers
- Avoidance of weather radars
- External antennas
- Antennas externes
- Ethernet networking skills
- Lightning protection
- Training
- Problems and warranty
- Security advice
- Warnings, cautions, and notes
- Caring for the environment
- Chapter 1: Product description
- Overview of the PTP 700 Series
- Wireless operation
- Ethernet bridging
- TDM bridging
- System management
- FIPS 140-2 mode
- Chapter 2: System hardware
- Outdoor unit (ODU)
- Power supply units (PSU)
- Antennas and antenna cabling
- Ethernet cabling
- PTP-SYNC unit
- GPS receiver
- Network indoor unit (NIDU)
- Chapter 3: System planning
- Typical deployment
- Site planning
- Grounding and lightning protection
- Lightning protection zones
- Site grounding system
- ODU and external antenna location
- ODU ambient temperature limits
- ODU wind loading
- Hazardous locations
- PSU DC power supply
- PSU location
- PTP-SYNC location
- GPS receiver location
- NIDU location
- Drop cable grounding points
- LPU location
- Multiple LPUs
- Radio spectrum planning
- Link planning
- Planning for connectorized units
- Configuration options for TDD synchronization
- Data network planning
- TDM network planning
- Network management planning
- Security planning
- System threshold, output power and link loss
- Data throughput capacity tables
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Type approvals
- FCC/IC compliance
- FCC product labels
- Industry Canada product labels
- 4.9 GHz FCC and IC notification
- Utilisation de la bande 4.9 GHz FCC et IC
- 5.1 GHz FCC notification
- 5.2 GHz and 5.4 GHz FCC and IC notification
- Utilisation de la bande 5.4 GHz FCC et IC
- 5.8 GHz FCC notification
- 5.8 GHz IC notification
- 5.1 GHz band edge channel power reduction
- 5.2 GHz band edge channel power reduction
- 5.4 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.4 GHz
- 5.8 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.8 GHz
- Selection of antennas
- European Union compliance
- Cambium Networks end user license agreement
Chapter 2: System hardware Network indoor unit (NIDU)
NIDU specifications
The NIDU conforms to the specifications listed in Table 44.
Table 44
NIDU
specifications
Category
Specification
Dimensions Width 172 mm (6.8 in)
Height 32 mm (1.3 in)
Depth 218 mm (8.6 in)
Weight 0.88 kg (1.95 lb)
Temperature -40°C (-40°F) to +60°C (+140°F)
Suitable for use indoors, or outdoors within a
weatherproofed cabinet.
Humidity 0 to 95%, non
‐
condensing
Waterproofing Not waterproof
DC Input +48 V to +60 V DC
Power consumption <8 W
The NIDU TDM interface conforms to the standards listed in TDM network planning on page 3-
48.
The pinouts of the NIDU ports are specified in Table 45, Table 46 and Table 47.
Table 45
NIDU LAN port pinouts
Pin no.
Connector pinout
signal name (*)
Signal description
Pin 1 LAN_PHYn_PAIR1+ Gigabit tx/rx pair 1
Pin 2 LAN_PHYn_PAIR1- Gigabit tx/rx pair 1
Pin 3 LAN_PHYn_PAIR2+ Gigabit tx/rx pair 2
Pin 4 LAN_PHYn_PAIR3+ Gigabit tx/rx pair 3
Pin 5 LAN_PHYn_PAIR3- Gigabit tx/rx pair 3
Pin 6 LAN_PHYn_PAIR2- Gigabit tx/rx pair 2
Pin 7 LAN_PHYn_PAIR4+ Gigabit tx/rx pair 4
Pin 8 LAN_PHYn_PAIR4- Gigabit tx/rx pair 4
(*) “n” refers to the LAN port number (1 or 2).
Table 46
NIDU ODU port pinouts
Pin no.
Connector pinout
signal name (*)
Signal description
Page 2-52