User's Guide Part 1
Table Of Contents
- Cambium PTP 700 Series User Guide
- Contents
- About This User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Important regulatory information
- Radar avoidance
- USA and Canada specific information
- Renseignements specifiques aux USA et au Canada
- EU Declaration of Conformity
- Application firmware
- Specific expertise and training for professional installers
- Avoidance of weather radars
- External antennas
- Antennas externes
- Ethernet networking skills
- Lightning protection
- Training
- Problems and warranty
- Security advice
- Warnings, cautions, and notes
- Caring for the environment
- Chapter 1: Product description
- Overview of the PTP 700 Series
- Wireless operation
- Ethernet bridging
- TDM bridging
- System management
- FIPS 140-2 mode
- Chapter 2: System hardware
- Outdoor unit (ODU)
- Power supply units (PSU)
- Antennas and antenna cabling
- Ethernet cabling
- PTP-SYNC unit
- GPS receiver
- Network indoor unit (NIDU)
- Chapter 3: System planning
- Typical deployment
- Site planning
- Grounding and lightning protection
- Lightning protection zones
- Site grounding system
- ODU and external antenna location
- ODU ambient temperature limits
- ODU wind loading
- Hazardous locations
- PSU DC power supply
- PSU location
- PTP-SYNC location
- GPS receiver location
- NIDU location
- Drop cable grounding points
- LPU location
- Multiple LPUs
- Radio spectrum planning
- Link planning
- Planning for connectorized units
- Configuration options for TDD synchronization
- Data network planning
- TDM network planning
- Network management planning
- Security planning
- System threshold, output power and link loss
- Data throughput capacity tables
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Type approvals
- FCC/IC compliance
- FCC product labels
- Industry Canada product labels
- 4.9 GHz FCC and IC notification
- Utilisation de la bande 4.9 GHz FCC et IC
- 5.1 GHz FCC notification
- 5.2 GHz and 5.4 GHz FCC and IC notification
- Utilisation de la bande 5.4 GHz FCC et IC
- 5.8 GHz FCC notification
- 5.8 GHz IC notification
- 5.1 GHz band edge channel power reduction
- 5.2 GHz band edge channel power reduction
- 5.4 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.4 GHz
- 5.8 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.8 GHz
- Selection of antennas
- European Union compliance
- Cambium Networks end user license agreement
Chapter 4: Legal and regulatory information Compliance with radio regulations
Réduction de puissance aux bords de la bande 5.4 GHz
La Puissance isotrope rayonnée équivalente (PIRE) est limitée dans les canaux en bord de la
bandes lorsque le PTP 700 est configuré pour utiliser la band 5,4 GHz aux les Etats-Unis ou au
Canada. La réduction de la PIRE a été déterminée lors de tests réglementaires et ne peut être
changée par des installateurs professionnels ou les utilisateurs. Les PTP 700 destinées aux USA
et Canada sont limitées pour opérer exclusivement aux États-Unis ou au Canada et ne peuvent
pas être configurés pour adhérer à la réglementation d’autres pays.
Le PTP 700 prend en compte le gain de l'antenne et les pertes des câbles de connexion
configurés par l'installateur professionnel via l'interface graphique pour limiter la PIRE pour
assurer la conformité à la réglementation en vigueur. Aucune action supplémentaire n'est
requise par l'installateur afin de réduire la puissance d'émission dans les canaux aux bords de
bande.
La PIRE maximale dans les canaux aux bords de bande 5,4 GHz pour les Etats-Unis et le
Canada est listée dans la Table 111.
Table 111
Edge channel power reduction in regulatory bands 12 and 13
Channel Bandwidth
Channel Frequency
Maximum EIRP
5 MHz Below 5476.0 MHz 24 dBm
Above 5720.0 MHz 24 dBm
10 MHz Below 5478.0 MHz 27 dBm
Above 5715.0 MHz 25 dBm
15 MHz Below 5480.0 MHz 29 dBm
Above 5709.0 MHz 26 dBm
20 MHz Below 5482.0 MHz 30 dBm
Above 5704.0 MHz 23 dBm
30 MHz Below 5492.0 MHz 27 dBm
Above 5694.0 MHz 25 dBm
40 MHz Below 5500.0 MHz 28 dBm
Above 5691.0 MHz 24 dBm
45 MHz Below 5508.0 MHz 24 dBm
Above 5686.0 MHz 22 dBm
5.8 GHz band edge channel power reduction
Transmitter power is restricted in edge channels when the PTP 700 is operated the 5.8 GHz
band with the USA or Canada country license. The amount of transmitter power reduction has
been determined during regulatory testing and cannot be changed by professional installers or
end users. Units intended for the USA and Canada market are locked for use in the USA or
Canada and cannot be operated under the regulations for other regulatory domains.
Page 4-36










