User's Guide Part 1
Table Of Contents
- Cambium PTP 700 Series User Guide
- Contents
- About This User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Important regulatory information
- Radar avoidance
- USA and Canada specific information
- Renseignements specifiques aux USA et au Canada
- EU Declaration of Conformity
- Application firmware
- Specific expertise and training for professional installers
- Avoidance of weather radars
- External antennas
- Antennas externes
- Ethernet networking skills
- Lightning protection
- Training
- Problems and warranty
- Security advice
- Warnings, cautions, and notes
- Caring for the environment
- Chapter 1: Product description
- Overview of the PTP 700 Series
- Wireless operation
- Ethernet bridging
- TDM bridging
- System management
- FIPS 140-2 mode
- Chapter 2: System hardware
- Outdoor unit (ODU)
- Power supply units (PSU)
- Antennas and antenna cabling
- Ethernet cabling
- PTP-SYNC unit
- GPS receiver
- Network indoor unit (NIDU)
- Chapter 3: System planning
- Typical deployment
- Site planning
- Grounding and lightning protection
- Lightning protection zones
- Site grounding system
- ODU and external antenna location
- ODU ambient temperature limits
- ODU wind loading
- Hazardous locations
- PSU DC power supply
- PSU location
- PTP-SYNC location
- GPS receiver location
- NIDU location
- Drop cable grounding points
- LPU location
- Multiple LPUs
- Radio spectrum planning
- Link planning
- Planning for connectorized units
- Configuration options for TDD synchronization
- Data network planning
- TDM network planning
- Network management planning
- Security planning
- System threshold, output power and link loss
- Data throughput capacity tables
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Type approvals
- FCC/IC compliance
- FCC product labels
- Industry Canada product labels
- 4.9 GHz FCC and IC notification
- Utilisation de la bande 4.9 GHz FCC et IC
- 5.1 GHz FCC notification
- 5.2 GHz and 5.4 GHz FCC and IC notification
- Utilisation de la bande 5.4 GHz FCC et IC
- 5.8 GHz FCC notification
- 5.8 GHz IC notification
- 5.1 GHz band edge channel power reduction
- 5.2 GHz band edge channel power reduction
- 5.4 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.4 GHz
- 5.8 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.8 GHz
- Selection of antennas
- European Union compliance
- Cambium Networks end user license agreement
Chapter 1: Product description Ethernet bridging
Second Data Service
This optional point-to-point transparent service offers a second virtual circuit for customer’s
data between one of the Ethernet ports at the local ODU and one of the Ethernet ports at an
associated remote ODU. The Data Service and Second Data Service are always mapped to
different ports at an ODU. The Data traffic of the two services are distinct and are separately
bridged to the appropriate configured remote ODU port.
The Second Data Service is available only with a Full capacity license.
The Second Data Service provides a single class of service, which can be configured to match
any of the eight classes of the Data Service.
Management Service
PTP 700 provides options for In-Band and Out-of-Band network management.
The In-Band Management Service connects management systems at both ends of the link with
the embedded management agents in the ODUs, accessed using the Ethernet ports selected to
the Data Service or the Second Data Service.
The Out-of-Band Management Service connects management systems at both ends of the link
with the embedded management agents in the ODUs, accessed using dedicated Ethernet ports.
Note
Out-of-Band Management is not available when the optional Second Data Service is
enabled.
The Out-of-Band Management Service provides a single class of service, which can be
configured to match any of the eight classes of the Data Service.
Note
The PTP 700 provides flexible interconnection of customer data and network
management using several Ethernet ports, but it does not contain a general-purpose
Ethernet switch, and it is not possible to forward traffic between the Ethernet ports of
the same ODU.
Local Management Service
PTP 700 provides option for local network management.
The Local Management network is isolated from the customer data network. Management
frames are not forwarded over the wireless link. The management agents can access only
through the OOB Local ports at the respective ODUs.
Further reading
For information about…
Refer to…
A more detailed description of the Data
Service
Data Service on page 1-20
Page 1-21