User's Guide Part 1
Table Of Contents
- Cambium PTP 700 Series User Guide
- Contents
- About This User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Important regulatory information
- Radar avoidance
- USA and Canada specific information
- Renseignements specifiques aux USA et au Canada
- EU Declaration of Conformity
- Application firmware
- Specific expertise and training for professional installers
- Avoidance of weather radars
- External antennas
- Antennas externes
- Ethernet networking skills
- Lightning protection
- Training
- Problems and warranty
- Security advice
- Warnings, cautions, and notes
- Caring for the environment
- Chapter 1: Product description
- Overview of the PTP 700 Series
- Wireless operation
- Ethernet bridging
- TDM bridging
- System management
- FIPS 140-2 mode
- Chapter 2: System hardware
- Outdoor unit (ODU)
- Power supply units (PSU)
- Antennas and antenna cabling
- Ethernet cabling
- PTP-SYNC unit
- GPS receiver
- Network indoor unit (NIDU)
- Chapter 3: System planning
- Typical deployment
- Site planning
- Grounding and lightning protection
- Lightning protection zones
- Site grounding system
- ODU and external antenna location
- ODU ambient temperature limits
- ODU wind loading
- Hazardous locations
- PSU DC power supply
- PSU location
- PTP-SYNC location
- GPS receiver location
- NIDU location
- Drop cable grounding points
- LPU location
- Multiple LPUs
- Radio spectrum planning
- Link planning
- Planning for connectorized units
- Configuration options for TDD synchronization
- Data network planning
- TDM network planning
- Network management planning
- Security planning
- System threshold, output power and link loss
- Data throughput capacity tables
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Type approvals
- FCC/IC compliance
- FCC product labels
- Industry Canada product labels
- 4.9 GHz FCC and IC notification
- Utilisation de la bande 4.9 GHz FCC et IC
- 5.1 GHz FCC notification
- 5.2 GHz and 5.4 GHz FCC and IC notification
- Utilisation de la bande 5.4 GHz FCC et IC
- 5.8 GHz FCC notification
- 5.8 GHz IC notification
- 5.1 GHz band edge channel power reduction
- 5.2 GHz band edge channel power reduction
- 5.4 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.4 GHz
- 5.8 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.8 GHz
- Selection of antennas
- European Union compliance
- Cambium Networks end user license agreement
Chapter 2: System hardware Outdoor unit (ODU)
Cambium description (*1)
Part number
PTP 700 Precise Network Timing Software License - per END C000070K003A
PTP 700 Group Access Software License - per END C000070K004A
PTP 700 FIPS 140-2 Upgrade including 128-bit AES - per END C000070K005A
PTP 700 FIPS 140-2 Upgrade including 256-bit AES - per END C000070K006A
PTP 700 Lite to Full Upgrade - per END C000070K008A
PTP 650/700 8-Port T1/E1 Software License (per END). C000065K049A
(*1) Order two upgrades per link.
(*2) Cambium Networks will supply AES upgrades only if there is official permission to export
AES encryption to the country of operation.
ODU accessories
Spare ODU port blanking plugs are available from Cambium Networks (Table 7).
Table 7
ODU accessory part numbers
Cambium description
Cambium part number
PTP 650/700 Series Blanking Plug Pack (Qty 10) N000065L036
ODU mounting brackets
The integrated mounting bracket (Figure 11) and connectorized mounting bracket (Figure 12)
are used to mount the PTP 700 ODUs on poles with diameters in the range 50 to 75 mm (2 to
3 inches). The extended integrated mounting bracket (Figure 13) is used for mounting an ODU
on poles with a diameter of either 90 mm (3.5 inches) or 115 mm (4.5 inches).
The large diameter extension kit (Figure 14) is be used with the integrated bracket to mount an
ODU on a pole with diameter up to 229 mm (9.0 inches).
Before ordering ODU mounting brackets, be aware of the following:
• Individual Connectorized+Integrated ODUs are supplied without a mounting bracket (Table
4).
• Individual Connectorized ODUs are supplied with a connectorized mounting bracket (Table
4).
• ODUs in kits are supplied with an integrated or connectorized bracket, as appropriate
(Table 5).
If separate ODU mounting brackets are required, order them from Cambium Networks (Table
8).
Page 2-9










