User's Guide Part 1
Table Of Contents
- Cambium PTP 700 Series User Guide
- Contents
- About This User Guide
- Contacting Cambium Networks
- Purpose
- Cross references
- Feedback
- Important regulatory information
- Radar avoidance
- USA and Canada specific information
- Renseignements specifiques aux USA et au Canada
- EU Declaration of Conformity
- Application firmware
- Specific expertise and training for professional installers
- Avoidance of weather radars
- External antennas
- Antennas externes
- Ethernet networking skills
- Lightning protection
- Training
- Problems and warranty
- Security advice
- Warnings, cautions, and notes
- Caring for the environment
- Chapter 1: Product description
- Overview of the PTP 700 Series
- Wireless operation
- Ethernet bridging
- TDM bridging
- System management
- FIPS 140-2 mode
- Chapter 2: System hardware
- Outdoor unit (ODU)
- Power supply units (PSU)
- Antennas and antenna cabling
- Ethernet cabling
- PTP-SYNC unit
- GPS receiver
- Network indoor unit (NIDU)
- Chapter 3: System planning
- Typical deployment
- Site planning
- Grounding and lightning protection
- Lightning protection zones
- Site grounding system
- ODU and external antenna location
- ODU ambient temperature limits
- ODU wind loading
- Hazardous locations
- PSU DC power supply
- PSU location
- PTP-SYNC location
- GPS receiver location
- NIDU location
- Drop cable grounding points
- LPU location
- Multiple LPUs
- Radio spectrum planning
- Link planning
- Planning for connectorized units
- Configuration options for TDD synchronization
- Data network planning
- TDM network planning
- Network management planning
- Security planning
- System threshold, output power and link loss
- Data throughput capacity tables
- Chapter 4: Legal and regulatory information
- Cambium Networks end user license agreement
- Definitions
- Acceptance of this agreement
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Compliance with safety standards
- Compliance with radio regulations
- Type approvals
- FCC/IC compliance
- FCC product labels
- Industry Canada product labels
- 4.9 GHz FCC and IC notification
- Utilisation de la bande 4.9 GHz FCC et IC
- 5.1 GHz FCC notification
- 5.2 GHz and 5.4 GHz FCC and IC notification
- Utilisation de la bande 5.4 GHz FCC et IC
- 5.8 GHz FCC notification
- 5.8 GHz IC notification
- 5.1 GHz band edge channel power reduction
- 5.2 GHz band edge channel power reduction
- 5.4 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.4 GHz
- 5.8 GHz band edge channel power reduction
- Réduction de puissance aux bords de la bande 5.8 GHz
- Selection of antennas
- European Union compliance
- Cambium Networks end user license agreement
Contents
Mounting the GPS receiver ...................................................................................................... 5-30
Preparing the GPS drop cable .................................................................................................. 5-30
Assembling an RJ45 plug and housing for GPS .................................................................... 5-31
Assembling a 12 way circular connector ................................................................................ 5-33
Connecting the GPS drop cable ............................................................................................... 5-37
Top grounding point for GPS adapter cable........................................................................... 5-38
Installing and connecting the GPS LPU .................................................................................. 5-39
Installing a NIDU .............................................................................................................................. 5-40
Mounting the NIDU ................................................................................................................... 5-40
Connecting the NIDU to the PSU, LAN and TDM cables ....................................................... 5-41
Connecting the NIDU to a DC power supply .......................................................................... 5-43
Installing an SFP Ethernet interface ............................................................................................... 5-46
Fitting the long cable gland ...................................................................................................... 5-48
Inserting the SFP module ......................................................................................................... 5-49
Connecting the cable ................................................................................................................ 5-51
Fitting the gland ........................................................................................................................ 5-52
Removing the cable and SFP module ..................................................................................... 5-54
Installing an Aux Ethernet interface ............................................................................................... 5-55
Supplemental installation information .......................................................................................... 5-56
Stripping drop cable ................................................................................................................. 5-56
Creating a drop cable grounding point ................................................................................... 5-57
Weatherproofing an N type connector .................................................................................... 5-60
Replacing PSU fuses ................................................................................................................. 5-63
Chapter 6:
Configuration and alignment ....................................................................................... 6-1
Preparing for configuration and alignment ..................................................................................... 6-2
Safety precautions ...................................................................................................................... 6-2
Regulatory compliance ............................................................................................................... 6-2
Selecting configuration options ................................................................................................. 6-3
Generating license keys .............................................................................................................. 6-3
Connecting to the unit ....................................................................................................................... 6-4
Configuring the management PC .............................................................................................. 6-4
Connecting to the PC and powering up .................................................................................... 6-5
Using the web interface ..................................................................................................................... 6-6
Logging into the web interface .................................................................................................. 6-6
Using the menu options ............................................................................................................. 6-7
Installation menu ............................................................................................................................... 6-9
Starting the Installation Wizard ................................................................................................. 6-9
Disarm Installation page ........................................................................................................... 6-10
Current Installation Summary page ........................................................................................ 6-10
Software License Key page ...................................................................................................... 6-11
Interface Configuration page ................................................................................................... 6-14
Wireless Configuration page .................................................................................................... 6-21
TDD synchronization page (optional) ...................................................................................... 6-27
Confirm Installation Configuration page ................................................................................. 6-29
System menu.................................................................................................................................... 6-30
System Configuration page ..................................................................................................... 6-30
Page vii