User's Guide Part 2
Table Of Contents
- Chapter 5: Installation
- Safety
- Hazardous locations
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- DC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- Grounding PTP-SYNC
- RF exposure near the antenna
- Minimum separation distances
- Grounding and lightning protection requirements
- Grounding cable installation methods
- Siting ODUs and antennas
- Thermal Safety
- ODU variants and mounting bracket options
- Installing the ODU and top LPU
- Install external antennas
- Installing the copper Cat5e Ethernet interface
- Installing the PSU
- Installing a PTP-SYNC unit
- Installing a GPS receiver
- Installing a NIDU
- Installing an SFP Ethernet interface
- Installing an Aux Ethernet interface
- Supplemental installation information
- Safety
Chapter 5: Installation Installing the copper Cat5e Ethernet interface
2
Fit the parts into the body and lightly screw on the gland nut (do not tighten it):
Connect the drop cable to the ODU (PSU port) and LPU
1
(a) Plug the RJ45 connector into the socket in the unit, ensuring that it snaps home.
(b) Fit the gland body to the RJ45 port and tighten it to a torque of 5.5 Nm (4.3 lb ft):
(a)
(b)
2
(a) Fit the gland nut and tighten until the rubber seal closes on the cable. (b) Do not over-
tighten the gland nut, as there is a risk of damage to its internal components:
(a)
(b)
Correct
Incorrect
Page 5-17