User's Guide Part 2

Chapter 5: Installation Installing the copper Cat5e Ethernet interface
Pin
Color
(Supplied cable)
Color
(Conventional)
Pins on plug face
1 Light Orange White/Orange
2 Orange Orange
3 Light Green White/Green
4 Blue Blue
5 Light Blue White/Blue
6 Green Green
7 Light Brown White/Brown
8 Brown Brown
Hoist and fix the main drop cable
Warning
Failure to obey the following precautions may result in injury or death:
• Use the hoisting grip to hoist one cable only. Attempting to hoist more than one
cable may cause the hoisting grip to break or the cables to fall.
• Do not use the hoisting grip for lowering cable unless the clamp is securely in place.
• Maintain tension on the hoisting grip during hoisting. Loss of tension can cause
dangerous movement of the cable and result in injury or death to personnel.
• Do not release tension on the grip until after the grip handle has been fastened to the
supporting structure.
• Do not apply any strain to the RJ45 connectors.
Caution
Do not lay the drop cable alongside a lightning air terminal.
1
Hoist the top end of the main drop cable up to the top LPU, following the hoist manufacturer’s
instructions. When the cable is in position, fasten the grip handle to
the supporting structure
and remov
e the hoist line.
2
Connect th
e main drop cable to the top LPU by following the procedure Connect the drop cable
to the ODU (PSU port) and LPU
on page 5-17.
3
R
un the main drop cable to the site of the bottom LPU.
4
Attach the main drop cable to the supporting structure
using site approved methods.
Page 5-20