User's Guide Part 2
Table Of Contents
- Chapter 5: Installation
- Safety
- Hazardous locations
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- DC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- Grounding PTP-SYNC
- RF exposure near the antenna
- Minimum separation distances
- Grounding and lightning protection requirements
- Grounding cable installation methods
- Siting ODUs and antennas
- Thermal Safety
- ODU variants and mounting bracket options
- Installing the ODU and top LPU
- Install external antennas
- Installing the copper Cat5e Ethernet interface
- Installing the PSU
- Installing a PTP-SYNC unit
- Installing a GPS receiver
- Installing a NIDU
- Installing an SFP Ethernet interface
- Installing an Aux Ethernet interface
- Supplemental installation information
- Safety
Chapter 5: Installation Installing a GPS receiver
3
Install the RJ45 crimp plug.
Start with tails over-length to assist insertion into load bar, then trim them to 5 mm (T).
Connect the RJ45 pins to the following conductors (Superior Essex BBDGe colors):
4
Assemble plug housing:
Depress the RJ45 locking tab (A).
Slide the plug housing assembly (B) over the RJ45 plug.
Tighten the sealing nut (C). This is easier to fully tighten when the plug housing is mated
to the socket of the adapter cable.
5
Check the assembly. This is an exampled of an assembled plug housing on the end of a drop
cable:
Page 5-32