User's Guide Part 2
Table Of Contents
- Chapter 5: Installation
- Safety
- Hazardous locations
- Power lines
- Working at heights
- PSU
- Grounding and protective earth
- DC supply
- Powering down before servicing
- Primary disconnect device
- External cables
- Drop cable tester
- Grounding PTP-SYNC
- RF exposure near the antenna
- Minimum separation distances
- Grounding and lightning protection requirements
- Grounding cable installation methods
- Siting ODUs and antennas
- Thermal Safety
- ODU variants and mounting bracket options
- Installing the ODU and top LPU
- Install external antennas
- Installing the copper Cat5e Ethernet interface
- Installing the PSU
- Installing a PTP-SYNC unit
- Installing a GPS receiver
- Installing a NIDU
- Installing an SFP Ethernet interface
- Installing an Aux Ethernet interface
- Supplemental installation information
- Safety
Chapter 5: Installation ODU variants and mounting bracket options
ODU variants and mounting bracket options
Mounting bracket options
The PTP 700 series supports five mounting bracket options. Select the optimum mounting
bracket arrangement based on the pole diameter and the ODU variant:
Table 113
ODU mounting bracket part numbers
Bracket
Pole diameter
ODU variants
Bracket part
number
Mounting bracket
(integrated)
40 mm to 82 mm
(1.6 inches to 3.2
inches)
PTP 700
Connectorized+Integrated
N000065L031
Mounting bracket
(connectorized)
40 mm to 82 mm
(1.6 inches to 3.2
inches)
PTP 700 Connectorized N000065L032
Extended integrated
mounting bracket
89 mm OR 114 mm
(3.5 inches OR 4.5
inches)
PTP 700 Connectorized
PTP 700
Connectorized+Integrated
N000065L030
Mounting bracket
(integrated) with large
diameter extension kit
89 mm to 229 mm
(3.5 inches to 9.0
inches)
PTP 700 Connectorized
PTP 700
Connectorized+Integrated
N000065L031
with
N000065L042
Note
The connectorized mounting bracket is included with the PTP 700 Connectorized ODU.
Order a bracket separately for PTP 700 Connectorized+Integrated ODUs.
Page 5-6