User's Manual

Chapter 6: Installation
Connecting Cat5e Ethernet cable
Page 6-56
Disconnecting an RJ45 and gland from a unit
To disconnect the Ethernet cable and gland from a unit, proceed as follows:
1
Hold the Ethernet cable and remove the gland back shell.
2
Use a small flathead screwdriver (0.2”/5mm wide or greater) to gently release the black
plastic watertight bushing from the compression fins, being careful not to damage the
bushing.
3
Unscrew the gland body from the AP, making sure that the Ethernet cable is not rotating
while disengaging the gland body from the AP housing.
4
Use a small screwdriver to depress the RJ45 locking clip.
5
Unplug the RJ45 cable.
6
Remove the gland from the cable, if necessary.