User's Manual

Chapter 7: Configuration

Configuring IP and Ethernet interfaces

Page 7-45

DHCP – BHS

Applicable products

PTP:



BHM

DHCP enables a device to be assigned a new IP address and TCP/IP parameters, including a default

gateway, whenever the device reboots. Thus DHCP reduces configuration time, conserves IP

addresses, and allows modules to be moved to a different network within the Cambium system.

In conjunction with the NAT features, each BHS provides:

 A DHCP server that assigns IP addresses to computers connected to the BHS by Ethernet

protocol.

 A DHCP client that receives an IP address for the BHS from a network DHCP server.

Reconnecting to the management PC

If the IP Address, Subnet Mask and Gateway IP Address of the unit have been updated to meet

network requirements, then reconfigure the local management PC to use an IP address that is valid

for the network. See Configuring the management PC on page 7-3.

Once the unit reboots, log in using the new IP address. See Logging into the web interface on page

7-5.

VLAN configuration for PMP

Applicable products

PMP :



VLAN Remarking

VLAN Remarking feature allows the user to change the VLAN ID and priority of both upstream

and downstream packets at the Ethernet Interface. The remarking configuration is available for:

1. VLAN ID re-marking

2. 802.1p priority re-marking

Note

For Q-in-Q VLAN tagged frame, re-marking is performed on the outer tag.