User's Manual

Chapter 7: Configuration
Configuring IP and Ethernet interfaces
Page 7-47
 Promote IPv4/IPv6 priority – The priority in the IP header is copied to the Q-tag/C-tag.
 Define priority – Specify the priority in the range of 0 to 7. This value is used as priority in the
Q-tag/C-tag.
MAC Address Mapped VID
If a packet arrives at the SM/BHS that is sourced from a device whose MAC address is in the
table, then the corresponding VID is used for that frame’s Q-tag (Q port) or C-tag (QinQ port).
The priority bits used in the Q-tag/C-tag are configurable similar to default port VID.
Provider VID
The provider VID is used for the S-tag. The priority bits used in the S-tag are configurable
similar to default port VID. Provider VID has an extra priority configuration:
 Copy inner tag 802.1p priority – The priority in the C-tag is copied to the S-tag.
Management VID
This VID is used to communicate with AP/BHM and SM/BHS for management purposes. The
priority bits used in the Q-tag are configurable similar to default port VID.
Use AP’s Management VID for ICC connected SM
This feature allows the SM to use the AP’s management VLAN ID when the SM is registered to
the AP via ICC. This feature is useful for the customer who uses a different management VID for
the SM and AP and Zero Touch feature is enabled for configuration. This parameter may be
accessed via the Configuration > VLAN page on the AP’s web management interface.