User's Manual

Chapter 7: Configuration
Configuring radio parameters
Page 7-144
 PTP 450i Series modules are available as connectorized radios,
which require the operator to adjust power to ensure regulatory
compliance.
The professional installer of the equipment has the responsibility to:
 Maintain awareness of applicable regulations.
 Calculate the permissible transmitter output power for the module.
 Confirm that the initial power setting is compliant with national or
regional regulations.
Confirm that the power setting is compliant following any reset of the
module to factory defaults.
External Gain
This value needs to correspond to the published gain of the antenna
used to ensure the radio will meet regulatory requirements.
Receive Quality
Debug
To aid in link performance monitoring, the BHM and BHS now report the
number of fragments received per modulation (i.e. QPSK, 16-QAM, 64-
QAM and 256-QAM) and per channel (polarization).
Note
Due to CPU load, this slightly degrades the packet during
per second processing.
Frame Alignment
Legacy Mode
See Table 131 PMP 450i AP Radio attributes - 5 GHz on page 7-130.