Installation Guide

Chapter 3: Operation System information
Page
3-25
LUID This field displays the LUID (logical unit ID) of the SM/BHS. As each SM or
BHS registers to the AP/BHM, the system assigns an LUID of 2 or a higher
unique number to the SM/BHS. If a SM/BHS loses registration with the
AP/BHS and then regains registration, the SM/BHS will retain the same LUID.
Note
Both the LUID and the MAC are hot links to open the interface
to the SM/BHS. In some instances, depending on network
activity and network design, this route to the interface yields a
blank web page. If this occurs, refresh your browser view.
Hardware This field displays the SMs or BHS hardware type.
Software Version This field displays the software release that operates on the SM/BHS, the
release date and time of the software.
FPGA Version This field displays the version of FPGA that runs on the SM/BHS
State This field displays the current status of the SM/BHS as either
•
IN SESSION
to indicate that the SM/BHS is currently registered to the
AP/BHM.
•
IDLE
to indicate that the SM/BHS was registered to the AP/BHM at one
time, but now is not.
This field also indicates whether the encryption scheme in the module is
enabled.